Porsche 911sc rear wheel bearing diy 

Nice Job Joe!! I Just Removed My Spring Plates and Torsion Tubes. Being This Far, I Probably Should Do the Wheel Bearings and Swing Arm Bushings. Thanks Again, Scotty

One of the best vids on the subject.. in the entirety of the internet... Thank you!

Might want to put some anti seize between the steel shroud and the aluminum arm. It will be appreciated in the future. Nice car.

Thanks for doing this I will do it soon.

I had the same problem getting my parking brake housing off the trailing arm. For your other viewers if you make two cuts on the side of the housing, you can then get the housing off without damaging it, and be able to weld it back together.

Is this a wide body kit or does the wheel/tire fitment just give that illusion?

🙌🏻 Nice work!

Great work! Consider painting the garage white for better lighting!

Great for the DIY..thanks..What are the metal pieces that you wound up having to tear away from the arm...? You said they were available new and were pricey. I cant believe that the bearing replacement would include tearing up two sheet metal parts to remove the bearings..Anyway, this gave me the confidence to move forward on replacing mine..and what new parts I may need when I do it..

Thanks for the DIY. What wheels are those?

👏🏼👏🏼👏🏼👏🏼👏🏼

Nice video - thanks for sharing. At 6 minutes, you’re hammering the hub while the arm is secured in the vice by the ear. Terrible, terrible idea. But otherwise, all good.

What vehicle life are you using?

16 or 17 inch bbs e50?

You might wanna build a better holding jig .....

Tire shine it