Here is a mix of channel 2 and channel 8 as an example in this video, in which when you move the joystick of channel 2, channel 8 will move together.
Enter the AUX-CHANNEL, check the switch of channel 8, which defaults to VrB.
Press End button to check the servo display. Channel 2--right joystick. Channel 8-- VrB. Channel 2 and channel 8 move independently now.
Enter the advance menu. PROG.MIX
Set MODE from Inh to ON/OFF.
SWB, UP means when I push the switch B UP, the mix is on.
Finally, RATE. It can be set from minus 100% to plus 100%. I want channel 2 and channel 8 to move with the same travel amount. So I set 100%. And I want them to move with the same direction, so I set it to plus 100, not minus 100.
Turn the dial set it to 100%, but you can set only one direction(转转盘), how to set the other RATE? Just need to move the joystick of the master channel, channel 2. They it will jump to the other rate. Press and set it to 100%.
Now, the programmable mix setting is done.
Let’s check the servo:
Turn VrB to adjust it to 0. Turn on the mix. When I push the joystick of channel 2, channel 8 moves together. But here’s one problem. The end point of channel 8 is only about 75. Why? Because the end point of channel 8 defaults to 75.
There are 2 values for two directions. Only 1 value can be set. How to adjust the other value? Also, Turn the switch of channel 8, VrB, it will jump to the other value.
Now the end point of channel 8 is both in 100.
Return to the servo display. Turn VrB to the neutral. 0. Push Switch B DOWN, the mix is turned ON. Push the joystick of channel2, channel 8 will move together.
Push Switch B UP, the mix is turned off.
Know more details about AT9S Pro via: www.radiolink.com/at9spro
Buy AT9S Pro via: www.radiolink.com/at9spro_whe...
Know more details about AT10II via: www.radiolink.com/at10ii
Buy AT10II via: www.radiolink.com/at10ii_wher...
You can send mails to after_service@radiolink.com.cn if you have any questions during using our products.
6 июн 2022
