Your video is better explained in common sense detail than even Premier's THC setup video. I am having some issues with diving and the torch moving my plate during a cut, rendering the part bad. Still playing with the height....
I saw your gantry moving at the end of the video as you were talking about the SD- so unrelated to the THC: are you able to program limits into your Mach 3? I tried it and reversed the A and Y motors. I would love to know my table can't crash and I saw one video explaining it but it wasn't able to do it.
If you would run self test on THC , if you measured voltage from Up and Down signals what would they be? I'm having issue, everything is set up as you have it but if I try to run test without plasma on my UCCNC does not receive any signals, and if I select active low , depending which side i select the axis moves to that direction without THC giving any signals
i could use a little help on your post processor in sheetcam what post processor are you using? the one i have is premiere plasma if this is the same as yours did you have to make any changes to the code in the post processor other then the offset. for the THC
Hello again, can you share the test that you show on your video? I finally has the proma to work on test mode, but no able to get it to work on mach 3. Thanks