Prop Shaft Seals and Carrier Bearing O Rings Replacement (Yamaha 225 HPDI Outboard)

Подписаться 7 тыс.

Просмотров 11 тыс.

50% 1

Get ready for the fishing season. Replacing the lower unit seals and o-rings. I hope this video helps someone get their boat together for the fishing season. Thanks for watching.
Any donations to the channel please us links below. Thanks You!
Cash App: $welch333
or
PayPal: michael-welch@comcast.net
But do not forget to check out my other channel "Michael You Can Fix That".
Other Channel "Michael You Can Fix That" -
/ @michaelyoucanfixthat

Опубликовано:

18 янв 2023

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 20

@jumpinggulley Год назад

Nifty tool there. Looked like a clean job. Shouldn't leak now.

@CrabBattles-zv9sk 10 месяцев назад

Great video! Even though the other lower unit disassembly videos have better quality and video work yours has way more valuable information. And visual information that is very helpful. Thanks.

@thebasshunter 10 месяцев назад

Thank for the comment!

@FRZNTYM1 5 месяцев назад

Nice job there Michael. Just a word - perhaps of caution when doing any work around those needle bearings. Best to pack a rag or small paper towel over those bearings. You do not want to contaminate those bearings with grit or dirt while fussing with them seals.

@kenp247 10 месяцев назад

Thanks, for sharing your knowledge with us. I've ordered the parts for my lower unit and will try to change the prop shaft seals without removing the carrier. I'm going to try the two screws and pry bar method.

@thebasshunter 10 месяцев назад

Good and it will save you a ton of money to do it yourself. Then you can do you buddy's boat when his need to be done.

@kenp247 10 месяцев назад

One question for you, if I have to remove the Bearing Carrier, can I do it without removing the lower unit?

@kenp247 10 месяцев назад

@@thebasshunter One question for you, if I need to remove the Bearing Carrier, can I do it without removing the lower unit ?

@thebasshunter 10 месяцев назад

@@kenp247 Yes, you do not have to remove the lower unit.

@magnumboyz1214 Год назад

👍👍

@andyelliott3977 Год назад

Nice video! Question: That grease zerk you mention @ 19:09, where does the grease go and when to grease it?

@thebasshunter Год назад

It goes to the back bearing in the lower unit. There is a bearing behind there.

@andyelliott3977 Год назад

@@thebasshunter Thanks!

@antho7475 Год назад

no it does not it only greases between the bearing carrier and the inside of the lower unit it does not grease any bearings all bearings are greased by the oil

@thebasshunter Год назад

@@antho7475 I'm sorry if I miss in formed you. I thought it greased the needle bearing that behind the two prop seal that I replace.