Quick and Easy! Bearing Race Removal in 3 minutes! 

Ok !!! You said the magic phrase " You are going to hit it hard and you are going to hit it often " You are awesome thanks!

Can't believe I'm watching this...... Should have stopped when I saw the sandals

watched 2 seconds just as a refresher. You can always tell a persons skill level by using the incorrect tool for the job. Ive never used a breaker bar or ratchet as a punch......

First time changing bearings. I had the right idea, just wasn't using enough force because I didn't want to damage anything. Big punch and hammer instead of a mallet did the trick. Thanks for the video.

Racer? What? It's a bearing race.

Invest in some drifts. Preferably brass ones so u can use them to reinstall the race without damaging them.

Officially a "cup" in tapered roller bearings. It is generally a separate PN from the "cone" (w/ rollers). A few are packaged as a cup & cone set, like Timken SET1, SET2, ... (National A1, A2, A3, ...). You don't need to source bearings from an auto manufacturer, just search for the PN's. I found that when needing an internal bearing for a transmission, which would cost $65 as an auto part with 3 wk delay. Found it was the same PN's as used on many trailer axles so bought the priciest one at a local trailer supply for $6. I used to tap the cups out of a wheel hub with a blunt screwdriver, but a tool which keeps it perpendicular is best. In one transmission, they weren't nice enough to have rear slots to get a punch on the cup, so had to cut it out with a carbide end mill until it cracked. Insure you orient the new cup correctly before knocking in or you will be in deep.

Good video- succinct and to the point. I do have to wonder though... why are all the people that know so much more about it watching videos on how to do it?

thanks was wandering if I could just leave em.. mine are really stuck. but gonna give it another go with some hard metal since that seem to be ok

Dude this worked like a charm thank you so much!!!

why do you call it a racer?

Racer? There's no R on the end of the word.

You need a brash punch NOT a steel breaker bar...........

That is not concrete, those are bricks! Hammering metal against red brick will easily chip or crack a brick. Concrete would stand a better chance. Race or races, not "racers".

Its a race... not a racer.