I rebuilt my pump according to your video steps. On startup it foamed like crazy. Tore it back apart and found the bushing on the shaft seal side spun and I had to beat the bushing off with a hammer. It turned fine as I assembled it. Shaft seal had a tear. Now to see if I can spec a tighter bearing OD. Thanks for your videos, they are very helpful.
Wish you would list the parts numbers on the parts you use for each video, I only have a cell phone so I have to watch video over and over to get the parts numbers Thank You 🙏 😊
I’ve never seen one of these Eaton pumps that can’t be fixed, it’s the bushing that goes bad and seal leaks, dealership closed so I got to find the bushing number to order, got several old ford tractor factory kits left but missing bushings
Great video I am currently rebuilding a pump. It's been about 30 years since my last rebuilt of this style pump. The pump that I am rebuilding is missing the filter retainer. Any ideas on where to get one or how to fab one.
I would like to replace the 2 bushing in my pump, can uou please tell me where you got your bushings, any additional information, such as bushing sizes and/or part numbers will be greatly appreciated. Thank you in advance.
Great video! Did you ever finish the first pump? If so, what did you use for a replacement flow control valve spring? I'm rebuilding mine using your video and my spring is broken. Thanks!
Sizes I used are in video at 36:26. I had a heck of time getting mine to not leak. I had to clean paint off the pump at that spot and tighten the heck out of of the fitting. Pretty sure I still have the metric o-rings in it too.