Remove And Replace PTO Seal Part 2

Подписаться 18 тыс.

Просмотров 101 тыс.

50% 1

Remove And Replace PTO Seal on a Ford 2000 Tractor. This video shows how I changed the PTO seal step by step. Use this video for reference and entertainment. I am not a professional ford tractor mechanic. This is my first time performing this procedure. This is part 2 of 2. In the first video I show how to remove the PTO shaft.

Опубликовано:

10 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 15

@MikeKincaid79 4 года назад

Exactly what I needed, thanks Bill!

@jasonbeason4780 2 года назад

Thank you for the video. Just made my job a little easier. Hey wanna come over and do one on my 53 Ferguson to30 😆. That would make it a lot easier 😆. Thanks again God bless you have a great day.

@waynegambrell7095 4 года назад

I pressed my new seal with a large 3/4" drive socket that fits the seal with a press. Just press it in until it is flush with the inside of the housing where the bearing is setting . You will see what i am talking about when you get everything apart, press it flush to where the housing is stepped down for the bearing.

@larrywoodruff7530 5 лет назад

If I tried this, everything that could go wrong would go wrong.

@diggerjim6977 2 года назад

I just tried it and everything that could go wrong DID go wrong 🤣

@jasonbeason4780 2 года назад

Well this sounds like my luck and here i go about to set a world record for the longest time to replace a pto shaft seal and gasket on a to30 Ferguson 😆

@moviesforrandy 2 года назад

i pulled the shaft all the way out and a bearing came out with it hope i can get it back in right. it was a round bearing about middle ways on the shaft.

@gurdipsingh153 5 лет назад

I take benefit now . Thanks

@dannywalker261 Год назад

Having trouble finding a seal, I have the same setup but having trouble getting a seal. Any information would be greatly appreciated. Thank you.

@PO2KickAss 2 года назад

Sir, I didn't see you install the gasket, which I'm sure you did. Did you use any sealant with the gasket?

@tonikume8364 6 лет назад

Thank you for your video :)

@billeaglerunner6844 6 лет назад

Thank you and thx for watching.

@tct1w 6 лет назад

U made is look easy enough. Thanks for the video. My old Ferguson needs a new seal. Should be about that same. Thanks!

@marksregister 5 лет назад

Thanks for editing and narrating the video without the garbage. I once watched a 20 minute video on how to change lawn mower blades. Should have been 2 minutes at the most. Anyway, regarding the PTO seal, I'm trying to decide if I'm going to hire it done or try it myself. Also, in my opinion, as long as you have it apart, might as well replace that bearing. I think it is not an expensive part.

@jasonbeason4780 2 года назад

@@marksregister hum i think ill order that bearing like you said its out and off so if it's out and off just as well do the bearing as well. Good thinking. God bless thanks for the brilliant idea.