This video explains the method I used to remove the output shaft and bearings from an RC-30 Omni style brush hog gear box. This gear sits on a bobcat brush hog, but is of similar style to many of the brush hog gear boxes out there.
Thank you! This got me thinking and I used an old brake rotor as your 2x4 and 2x4s as the spacer. Mine was rusted inside and it took a lot to get out then a few taps. For the back bearing I used the greasy rag trick. I punched pieces of a greasy rag into the center of the rear bearing and it pushed it out. Thanks again! This what youtube is for!
I owe you an apology and thank you! I thought my puller and tools would work better so I spent 3 hours and 2 bandaids later to finally give up. Then I built your puller and 5 minutes later I was done! Thank you!!!!!
I think I wedged a screwdriver to pin one side and kept it from spinning and used a second one to work the retaining clip off. Now that you mention it, I recall it being a pain.
