Removing the rear hub and replacing the bearings in the Yamaha Rhino! 

Glad it helped brother

You can add a little but the new bearings have a little grease in them from the factory. You can pop the seal out and add some but becareful and don't damage the seal.

They are sealed bearings

I bought a bearing puller at Harbor Freight but the smallest adaptor was too big. Do you know if they still sell the puller in the video and what they call it?

This is the only one on their site. I don't remember what the inside diameter was on the bearings but I would think this one would still work. www.harborfreight.com/slide-hammer-and-bearing-puller-set-5-piece-62601.html

@@mudandgutsoffroad thanks.

@@travharrell1713 your welcome

it's a blind bearing puller from harbor freight!

+Neil Davidson thanks. what bearings you use for front wheels?

+raja gee I had good luck out of Quadboss bearings!

+Neil Davidson does quadboos makes bearings for front wheels? where can i get them from online?

+raja gee eBay is the cheapest place I have found, sometimes Amazon does two. I usually shop between the two.

Melissa Brown left to loosen if I remember correctly.

He said 32mm but you can use 1-1/4in. Same size.

I generally use all Quadboss bearings ball joints and such. I do the same on the Rzr