Hey, great video! I see you soldered the new power switch onto the back of the board. I was wondering, would you be able to unsolder the old switch and replace it with the new one - then feed it through to where the old button was? Sure it’d look a little tacky. Is there another function of the old switch that would cause removing it to cause complications?
I have one of those with the exact same problem, but try and find one of those switches is near impossible even though they were used on numerous tv's as well, it now sits in my stack of broken gear, which is too bad 'cause they're a sleeper of an amp @ about 85watts rms per channel, so its going to sit until I find a donor out of something.
