Тёмный
No video :(

Restricted Drop Link #43 - Brunswick Pinsetter Adjustment 

Shawn M Bowling
Подписаться 682
Просмотров 681
50% 1

Today I will be showing you how to adjust your restricted drop link
Outro song:
Track: Max Brhon - Redemption [NCS Release]
Music provided by NoCopyrightSounds.
Watch: • Max Brhon - Redemption...
Free Download / Stream: ncs.io/MB_Redemption

Опубликовано:

 

2 июл 2023

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 10   
@CapKing2024
@CapKing2024 Год назад
This guy is gold!
@mangaman88188280
@mangaman88188280 Год назад
Great advice on making the spacer on the deck lift shaft thicker, I've had to do that a couple times and it's a lot easier than drilling new holes.
@shawnmbowling
@shawnmbowling Год назад
Right! Don’t understand how they didn’t think of that back in the day
@patrickwalker1740
@patrickwalker1740 13 дней назад
Another way to look into doing this adjustment is dropping the deck to 270,remove spring on the finger, loosening the rd curved link, and then just finger tightening the bolts back. Run the machine back to zero and it will self adjust…. Drop machine back down tighten the bolts , put spring back on and your golden
@ilovetoysto1
@ilovetoysto1 8 месяцев назад
Actually at 270 you grab the curved link it should have very little or no movement up down. If it does this tells you the allen screw going threw the blocking finger has come loose.When this happens it will greatly effect the amount your blocking finger will raise up at 0 degrees.. When loosening bolts on the curved link if you run out of adjustment with the slotted holes dont be affraid to use small round file slot the 2 holes your curved link if you need more adjustment...Best of luck.
@RockOn829
@RockOn829 Год назад
That shoulder bolt gets worn so change it to stop too much play...slop in it. Plus put a small tab on grease on it. Yes a bigger spacer if needed...if needed.
@shawnmbowling
@shawnmbowling Год назад
Didn’t think about that bolt at the time, but yes you are 100% correct!
@lockedonlaw
@lockedonlaw 19 дней назад
Yea, it's a bit hard to do this one with the fucking deck right in the way.
@shawndale7344
@shawndale7344 9 месяцев назад
may i ask what problem or trouble led you to know to adjust the drop link to begin with?
@shawnmbowling
@shawnmbowling 9 месяцев назад
The interlock probe was getting caught on the blocking finger, so seen that the finger could move up more and made it do that
Далее
The BARNS are EMPTY...
32:20
Просмотров 92 тыс.
Respots - Brunswick Pinsetter Calls to Service
11:25
Просмотров 1,7 тыс.
Turret Spider C/O - Brunswick Pinsetter Repairs
41:01
OOR - Brunswick Pinsetter Calls to Service
7:52