Videos covers the DIY installation and retrofit bi-xenon projectors into factory halogen headlights. It shows how to remove your headlights, how to polish your headlights correct, how to remove the lens from the headlight housing, how to install the projector into the headlight, and finally it shows before and after pictures.
The projectors used in this video are mini H1 bixenon projectors. They are designed for vehicles that have factory H4 or 9003 halogen headlights. The retrofit headlights were installed on a 2002 1st gen Toyota Tacoma.
The procedure is as follows:
1. remove headlights from vehicle (this is different based on your car)
2. Remove all of the auxiliary items from the headlights
3. Bake the headlights for 290 degrees for around 5-10 mins
4. pry the lens open using leverage
5. Remove the bulb holder and securing nut from projector
6. Drill a small hole in the headlights for the bi-xenon wires
7. Insert H4 ring into headlight and install projector putting silicone anti-vibration ring on the back of the projector before sliding it into place. Make sure bi-xenon wires are routed through the hole drilled into the lights. When the projector is fully seated, use the securing nut to tighten it. Reinstall the bulb holder.
8. Epoxy and glue in the chrome shroud
9. Use windshield gasket maker around the perimeter of the house and reinsert lens. Use some pliers to secure lens back to headlight
10. Bake again at 290 degrees for 5-10 mins
11. insert HID and get wiring completed
12. Reinsert in car and enjoy!
4 авг 2024
