RLAARLO OMNI TERMINATOR Hits 83mph!  

Thanks man!

Thanks for stopping in buddy!👍

Thanks buddy!

Thanks buddy, it looks like its stable in this clip, but I could barely get it to full trigger without spinning out or recking it this night! I went 83mph the pass before this one, but I spun the tires and tumbled it violently! lol. I think I can fit a slightly bigger pinion so will see what happens!?

@@micron3268 Well good job getting a clean run in! I was impressed!

I have not had any trouble with the truck so far! Thanks for stopping in!

I have the 130amp spektrum esc in it with the spektrum 3200kv 3660 motor with a 35t pinion gear, I haven't touched anything on the truck except installing the electronics and tires and lowering the suspension! A 120amp esc should work great for you, good luck man👍

@@micron3268 i used a 3652-3300kv last night I thought other was fast but this moved

If you're using it for speed runs try foams, but for bashing I really don't know what to tell you man!

@micron3268 ya just for speed runs. Bc in quite sure w The way I have it set up right now it goes somewhere between 70-90mph for sure

Yes, 4s is in it! Thanks for taking a look!

@@micron3268 did you get the Spektrum 130amp Esc Spektrum 3660 3200kv motor from Amain Hobbies?

@@micron3268 have you had any problems with the controller like I have?

@@maxs6231 I have never seen or used a Rlaarlo controller. This was the carbon roller so I'm using a Radiolink Rc4gs V3 controller and I do recommend Radiolink Rc4gs V3 or Rc6gs V3 for a low cost but very good controller if you end up needing something new!

@@micron3268 Okay thanks I might do that.I Have the RTR carbon and the controller is just absolutely terrible.