S2EP15- How to Remove Semi floating Rear axle and replace wheel bearing, FJ40, BJ40, FJ45

Подписаться 11 тыс.

Просмотров 7 тыс.

50% 1

Semi floating axle bearing removal and replacement, the bearing where not playing nice so I took them on with a grinder and a welder to remove them both! Worked perfectly, but if you try this at home please take your time and take care not to cut the axle or welding into the axle tube.
R1 from - chemtools.com.au
Tools from - toolking.com.au
Parts from - onlineautopart.com.au

Опубликовано:

14 окт 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 18

@bigwavedave321 2 месяца назад

Amazing! Great tricks! I would have never attempted this before. Your videos are priceless. Thank you!

@kyleroe2665 3 года назад

This made me realise how much easier a full floating hub is to rebuild.

@40ChannelCruiser 3 года назад

Yep you're spot on, much easier to re-build a full floating hub!

@Chuckles1418 3 года назад

For those retaining bolts in the hubs - if they aren’t playing ball a hammer driven impact would be my go too (especially if you have to cut your own screwdriver slot). I use it on motorbike clutch covers and brake reservoir caps that have a habit of rusting in.

@40ChannelCruiser 3 года назад

Thanks for sharing your tip Mate, will keep it in the memory bank👍

@thelandcruiserproject5421 3 года назад

Thats such a good trick, I will need to try that....

@cr_xxy7094 3 года назад

You are the best 👌

@dannyconelly1454 3 года назад

I learnt something today! Thanks Jase!

@40ChannelCruiser 3 года назад

You are very welcome.

@68pitty 3 года назад

18.45 Hope you got that roller out. Top job

@40ChannelCruiser 3 года назад

Thanks mate, Yep sure did.

@garydavo07 3 года назад

Cold up there? Bloody cold here in Melboume

@40ChannelCruiser 3 года назад

Yep sure is, we have had some -5 mornings, lots of thick fog and frost and a couple of snow days.

@Habibullah-rj8ry 7 месяцев назад

Many greetings from Germany. A question? Do you also speak German?

@cr_xxy7094 3 года назад

Do you know the number of the oil used in the diffusers fj40 1979

@40ChannelCruiser 3 года назад

I use 80W-90, Oh no I have given away some of part 2. 😂

@RonaldStoddard-ld6li 11 месяцев назад

I used my old bearing to put the new bearing in. Big mistake. I couldn’t get it out. I had to pull both bearings and start over. Cost me another bearing. Would be fine, but don’t pound in in all the way where the seal seats…. You won’t be able to get it out!

@RonaldStoddard-ld6li 9 месяцев назад

I don’t recall Jack mentioning making a cut in the old Bearing when using this way. That might have been helpful information