Scooter Manual Choke Conversion Kit 

Hello my friend thank you for watching my video and if you need any help feel free visit my channel for lots of good step by step videos or contact me anytime now remember be safe and ride smart

Thanks for the visit

hammerheadperformance.com/manual-choke-for-150cc

If you're experiencing issues with your scooter's idle and throttle after reinstalling the choke, it's likely that the choke isn't installed correctly or is not adjusted properly. Here's a step-by-step guide to reinstalling and adjusting the choke on your scooter: Remove the Choke: Start by removing the choke from your scooter. Make sure to note how it was originally installed so you can reassemble it correctly. Inspect the Choke: Check the choke for any signs of damage or wear. If it's damaged, it may need to be replaced. Clean the Choke: If the choke appears dirty or clogged, clean it to ensure proper functioning. Reinstall the Choke: Carefully reinstall the choke into its original position on the scooter. Make sure all connections are secure and tightened properly. Check Idle and Throttle: After reinstalling and adjusting the choke, start the scooter and allow it to idle. Monitor the idle speed to ensure it's stable and at the correct RPM. Additionally, test the throttle to make sure it responds smoothly and without any hesitation. Make sure when you reinstall the enricher you have the rubber gasket around the choke because sometime the brake easily and if it brake air will go inside Consult a Professional: If you're still experiencing issues after following these steps, it may be best to consult a professional mechanic or technician who has experience with scooter engines. They can diagnose any underlying problems and make the necessary repairs or adjustments. By following these steps, you should be able to reinstall and adjust the choke on your scooter correctly, restoring normal idle and throttle operation. Thank you for watching my video

Hello my friend unfortunately I do not have a Kymco to make a video but I can tell you to make sure every 1000 miles change the motor oil , clean or inspect the air filter , Inspect your tire and brakes every 3000 miles change your sparkplug , change gear oil and inspect fuel filter, and every 6k to 7k adjust your valves clearance, clean your carburator jets and replace air filter. Thank you for watching my video

Hello my friend for a 50cc 1400 rpm at idle for the 75 cc 1600 rpm at idle . Thank you for watching my video

The chokes are the same on 150 and 50

Hello my friend no they do not have that on Amazon check this link hammerheadperformance.com/manual-choke-for-150cc

@@VirberelloScooterTips thank you brother

Yes the electric start will work fine 👍

Hello my friend the enricher with get the power from the ac stator and no positive pole or negative pole is not important for the enricher

Thank you very much

Hello my friend thank you for watching my video

Hello my friend I think you need to replace the regulator rectifier amzn.to/3lyunhg or you have a short on the wires somewhere in the system . Thank you for watching my video

When I turn off my scooter completely the front lights stays on and that’s causing my battery to die

Is there another way I can contact you in case I’m having another issue with my scooter. I watch ur videos on fixing the scooter and you know a lot about it

Hello Mikey that is not normal after little time the electric enricher they age because they have an little gel inside that no longer expend and that will not close perfectly the choker hole. Thank you for watching my video

@@VirberelloScooterTips I just put a new carburetor on so that can't be it right?

@@Manwichman new carb should be ok but anything is possible with gy6 scooter parts

Hello my friend if your scooter is not starting right away you may have to place a new spark plug or an iridium spark plug so your scooter will start at the first touch sometime scooter need little small adjustments in order to work properly . Thank you for watching my video

@@VirberelloScooterTips I changed the spark plug and it still doesn’t turn on right away. Oh and I order the voltage regulator that you link to me It didn’t come with cables was it suppose to come with cables

@@Cristopher180- Hello my friend no the regulator is not coming with wires is just a little box make sure you place the connection the same way you have right now

@@VirberelloScooterTips so I don’t need to order any wires

@@Cristopher180- no the regulator is just click and plug in I hope that before you order you look at the regulator that you have on your scooter because some gy6 have a flat connection and some regulator have a square anyway I like amazon because you can always send the part back very easy and get credit

ah ah ah yes all together ah ah ah

Ah ah ah you funny

@@VirberelloScooterTips You do a great job. I've watched a lot of your videos. Your english is very good.