God bless you. I have very little patience with myself. Trying to figure this out just made me so frustrated. But you made it perfectly clear and understandable. Thank you.
Good video, I Just got one and you can set up the handles and tighten first. Then you can install it on the mower, the end of the bars flex easily to put 1 side first then the other, then lastly put the ring in the grooves carefully and tap in with the back if the screwdriver handle…. Others wanting to know how to adjust it, theirs 2 black knobs above the roller that u remove 1 at a time and shows 3 holes/slots on a vertical plate. Lower hole is the highest cut setting and (it’s already set to the middle hole for medium cut) and top hole is for lowest setting . I suggest bottom hole for highest setting especially for summer…. I kinda need it to go higher but it’s all maxed height 👍👍👍
Thank you so much, mine came with no assembly instructions. Once I watched your video, and grabbed the tools you recommended, we were able to assemble in minutes.
I had made the same mistake you just made with the screws... They are squared for a reason you take off washer and when you insert screws to holes you line up the screw to fit inside the squared hole and that locks the screw and you don't need the pliers to hold for tightening! Saw it from another video I accidentally hit while trying to go back on yours haha
I just found one of these for free in my neighborhood, they had put the handle bars in the wrong place and was impossible to use, why I think they just set it on the curb, but moved the handles to the right spot and now it works legit, cheers for the vid
Lucky guy lol spray some wd-40 on the wheels and blade, and ur good to go. Just bought 1 for $80 for my new grass and I gotta figure out how to raise it higher… cuts too short even at highest setting
@@B_HarTz WD? Gotcha ok, will do. Maybe bigger wheels for yours?... If it's on the highest setting. Or adding some kind of rings around the wheels to enlarge them haha, idk. Good luck 🤘🏼 cheers
I got stumped on the e rings. I saw tools on those things and got frustrated. I tried pushing it in. All i needed was to be shown how ya did it. Thanks 😊
Super helpful, thanks! The info I still wondered about after watching and assembling was which side to put the washers on: bolt side or wing nut side? I did it wrong.
I returned mine so I can’t send a pic but the E ring looks like an E in a circular form. There’s a diagram in the manual that shows exactly where it goes. And yes, the manual also said that just pushing the mower will sharpen the blades. Those blades are designed to sharpen as you move it
