Scratch Building an RC Airplane: Flying Wires with Mick Reeves Fork End Connectors 

That solder joint, I think you would have been better off cutting a slit in the rod wide enough to slip that flat stock between the slit and then soldering them together, this would make a stronger joint than a butt joint. You've done really good work on the aircraft. My thoughts are during flight the vibration caused by the motor and the air moving over the flat bar will weaken the solder butt joint over time and might lead to the failure of the flying wires.

Great stuff. You definitely have the talent to be a great modeler. Thanks again for the shout out for my channel too, it helps (Grant Aston).

Where's the link to the products I'm curious and need those turnbuckes

Where did you get the wire? I have a bipe in the works that I would like to add fling wire to.

that joint is the weakest part of the wire butt joint no good you done it as best as you could i would overlap on the fitting 10 mm use silver solder rod with flux and round off put heat shrink over would look ok if those wires break you will have the walk of shame