Secrets of Being Leveled on 35s 

You ain't lying.

Jess Crayton you are spot on! I’m not sure on the leveling kit’s correct height due to being previously installed before I got the truck.

Have you tried a wheel spacer just a small one

Thanks. Yes amp research steps are my next thing on the list to do to it.

That's what I was gonna say need the powersteps!!

Jon Clark Thanks man. It already came with a leveling kit on it when I brought it. I was going to go with a 3in level but I seen I could clear without doing it. But I installed leveling kits on trucks.

I need you get with you man! ASAP

I have 1/4 pacer on mine and it still rubs the sway bar. You may can try 1/2 spacer and that should get you on the sway bar, but you will have to watch out for the bumper then.

@@parkersgarage6680 yeah it’s dangerously close as it is. Time to break out the saw, Johnny Knoxville style 😂

@@parkersgarage6680 you’ve got a gorgeous truck man. Mines only a 15 lt with leather but it still cleaned up nice

@@jamesyork6023 Hey that’s all that matters. Did you take your lower part of your bumper off? I was going to try 1/2 but I never got around to it. I have done got use to driving with it so I hardly ever rub the sway bar anymore.

@@parkersgarage6680 I did, mine is a 2015 so I’m not sure in the difference of them vs yours. I just try to be as careful as possible now. You got insta brother? Hell of a build, I’ll give ya a follow!

You shouldn’t have any problems with rubbing with a 33. You should have plenty of room.

I Have a 2017 1500 and installed 2 1/2 leveling block under the shock and run 275/70R18(33x10.8) on stock wheels with no rubbing.

It’s a 2016 and yes I had to cut about 2” or so off the mounts that keep the back of the seat secured to the body.

Robbie Jaegle no rub on the fenders. Only place that it runs is the sway bar. I’m going to do a in depth video of it here soon.

Sounds good mine has The gm mug guards I’d hope it clears will probably go buy some after I see your other video u post

Love them snow flake rims too!

Tyrone Mr J it’s a 2in level on it. No trimming or anything. Only rubs sway bar on full lock.

@@parkersgarage6680 ok thank you so much for the information

@@parkersgarage6680 What brand 2 inch leveling kit are you running on front and what is the rear leveled to?

JC Garage I’m honestly not sure what brand level it is. It was already installed when I brought the truck. The rear is also leveled with air bags also.

@@parkersgarage6680you think i can run 22’s on 35’s ? i have a 2 1/2 front leveling kit in the front , but stock rear

Raul Rivera I don’t a buddy gave the cutout to me. Just get a cutout that has a motor on it similar to a window motor. They work the best.

Eric B it all depends on what kind of tire you get and how wide the tire is. The part that rubs is the side wall of the tire. If you go with ones with big aggressive side wall then you will rub. But if you get a non aggressive side wall then the likely chances of you rubbing goes down.

Good to know thanks I’m planning on going with Toyo open country at3

They are vinyl wrapped gloss black.

Yes you can. Those rims I had were factory offset. It only rubbed alittle on the sway bar and the edge of the fender

Same question

Devon Watts it doesn’t rub anywhere but the sway bar at full lock.

Parker’s Garage thanks! 👍🏽

Do you have a stock control arm ?

It’s a 2in lift but a 3in will give you more clearance.

It doesn’t have any cutting or trimming done to it. Only had to removed the mud flaps and the lower trim piece on the bumper.

It rides smooth and it has the stock struts on it. There is some tire noise once’s the tires wear.

Yes that is custom. You have to removed the seats and cut a small section of the brackets that hold the seat to back of the cab. I believe it was an inch or so. Super simple to do.

@@parkersgarage6680 thanks so much for the info!!! Do u still have the truck and if so how is it??

@@slidewayz432 unfortunately I don’t have the truck anymore.

Probably a 3 inch leveling kit

@@robertrobinette445 it's around a 2 or 2.5 cuz he commented that he wanted a 3 inch

I do believe it was a 2” or a 2.5” level. It was already installed before I brought the truck.

bryan brooks it’s a 5.3. With my tune it affects gas mileage for sure but power not so much. I can easily turn them over with no hesitation. I’m not really sure if I didn’t have my truck tuned if it would affect any power.

@@parkersgarage6680 what tune do you have and do the 35s make it set higher

bryan brooks I have a laptop tune from hp tuner on it I’m not sure what the specs are but it’s a fuel mileage tune. I was getting 22 mph before I put the 35s on it and it may have raised it up an inch or so not much that you can tell it honestly.

@@parkersgarage6680 thank you

I bought mine at a local tire and rim shop near me. They had the best price at the time.

Jay Simz they are more of a mud tire than anything.

Alexander Capuano the wheels are a 22x9

That’s the air line going to the air bag. It’s actually under the frame rail. But it does look like it’s on the exhaust. It was previously installed before I got the truck.

@@parkersgarage6680 Awesome! Hey, just pointing it out. Thanks for the reply mam!!👍👍

It is. I have a laptop tune on it for fuel mileage. But it doesn’t help mileage any with these 35s on it.

@@parkersgarage6680 so I have a question, I have a 2014 and I wanna get rid of the muffler and add a straight pipe to get some rumble but if I do that do I need to leave the valve in the pipe that opens and closes on the inside or will that mess up the afm?

@@Jayden_2261 no it will not mess anything up, all the flap does is opens and closes when the truck has back pressure(V8 mode) or doesn’t have back pressure (V4 mode). The honestly only difference it may make is that it may sound slightly different, nothing to noticeable. I have mine stuck open at all times.

@@parkersgarage6680 okay thanks man I’ll just take them and the muffler out, and good video I’ll subscribe and keep up on these I love watchin Chevy Silverado videos haha

@@parkersgarage6680 so if I just take out the muffler and leave the flap valve in there would it sound better or no?

Obviously you don’t know a 35 and a 22 when you see them. I would be a lot less tire if it was 33”. Thanks for the comment though!

It just involves alittle bit of cutting on the back seats. Nothing that is to bad noticeable. I could do a video on it if you would like.