serpentine belt replacement chevy impala 

The fuel filter inside the tank does not open as long as the car is running well.

Raise the engine mount a bit and then remove the belt

@@Autoenginecheck thank you!

Was the car already on jacks stand when you jack the engine or you just jack it up straight to the engine to get the job done . Another question please I drove my car through a flooded now it’s making noise when I turn on the engine then it give me rough idle when I tried to accelerate guck

Yes sir black pulley water pump same work

Oil pans jacked a wooden pich Otherwise, oil pans can be baked Thanks FOR comment sir

Yes sir no

@@Autoenginecheckhuh? Yes or no?

@@user-zc1jt3zb3vI think he was answering your statement and then your question 😂😂😂 I’ll be here to answer all further questions

I'm trying to figure out how to do my alternator as well it's litterly no videos of substance on how to replace an alternator but I'm sure this close

@@gabenolan5895 this was the best video. Just make sure you remember the belt routing system.

@@gabenolan5895 also be careful when disconnecting the radiator fan those little plugs are very fragile. I had to superglue mines back

@@gabenolan5895 you have to remove the fan

The engine mount can be opened with a car jack and a piece of wood on it

@@Autoenginecheck Thanks for answering me back, i watched ur video over 100 times, u Have the Only video On RU-vid Showing this Mount , i gave up for today, i'll try again in da morning, Does that mean Lifting engine slightly Higher with the wood on Oil Pan ?

Thanks for comment

The screw is the long drawn pulley You can use the jack you used to open the mount up or down, I had no problem opening the pulley.

Thank you so much. The jack did the job. I got it off... But what size ratchet did you use for the tensioner pulley ?

​@@patl2947 I see this was two months ago. I'm doing this job today. Did you ever find out what size rachet you need for the tension pulley.

@Kenney KatFish Ten Yard Fight It's a 1/2 drive 2 inches length. I ended up using an breaker bar

+971 50 614 2129 please call for details

Yes sir

Why

To take the weight off of the engine mount so it can be removed.​@@jonathancristobal4724

13 mm Bolt 30 Nm tight