Singer Touch & Sew - Troubleshooting bobbin thread snagging, thread nesting 

Using your examples/axplanations and some fiddling managed to fix the problem I was having with my 626's threading, thanks so much!

These videos are super helpful

I battled with this problem for weeks!! I ordered tools to measure the spacing of all the parts, I was on a Facebook page and tried tons of things. I watched tons of RU-vid videos, rethreaded and changed bobbins and threads. I was beyond frustrated. Then a wise FaceBook guy suggested I start from the basics - change thread and bobbins, clean out the bobbin area (had done all of those things) and oil it! As soon as I OILED the bobbin case the problem stopped!!!! I had fully cleaned and oiled everywhere metal moving over metal touched EXCEPT the bobbin area! Ta-Da!!!! 😂

These videos are awesome, thank you so much for posting! I have a machine similar to this that winds in the bobbin case. The thread, like yours, is going under the bobbin case and not actually winding. How do I get it to wind? Is there something I need to adjust as far as how it's screwed in or is it something else?

I took the needle plate off a Singer 4423 to watch where the thread was going and the bobbin kept popping out. I found out from a RU-vidr, that the needle plate is part of what holds the bobbin in place

Most people do not realize there were 4 production "runs" of the # 600E machine. The one you are working on is a later "run" and plagued with more issues.. The needle bar has nylon bearings, the motor lost the top ball bearing ( replaced with a sleeve bearing ), the cam stack became plastic as well as the cam follower. Only the rare 1st run of these machines is decent ( basically the same as a # 600 )..

I have the 600e metal gear machine. You should not have to take the track out to remove the bobbin case. It flips up slightly and then you just ritste the bobbin case back and forth slightly and it will lift right out.

The ring below the bobbin holder doesnt move when i press the pedal. I can move it manually. But the whole bobbin compartment doesnt move when i move the needle up and down...help?

Do you have any idea why the bobbin would be lifting up when sewing?

How to remove bottom plate

The tab on my bobbin case will not lock into place. Help? I have removed the case and the latches. I did notice the bobbin case has what seems to be a screw which fastens into nothing. Does this indicate the bobbin case is broken? I have the model 600

Not all touch and sews are equal. The original ones are far superior than the later models.

What do I do if the spiny thing doesn't spin??? Please help 😢

I live in knoxville Tn. I need help with my Touch & sew. The piece that holds the bobbin lockes up

Help. I took the top off my 755 touch and sew it that someone gave me. Cleaned and oiled a nd cant get lid alligned properly. Side door may be at fault. Don't want to pay a pro. 😮😮😮