Hello! fantastic video! i have sculpfun s9 but when i try to remove varnish i see small line in my design...the varnish is not completly remove...how can i do? i use power 10%, interval 0,08 and velocity 40 mm/s...
Tenho uma S30 Pro, essa empresa só quer vender não dá nenhum tipo de suporte aos clientes, e quando perguntamos algo eles respondem outro assunto aleatório, arrependimento total.
Hi friend, thanks for the great video; I have a few questions: 1) What kind of ink did you use in engraving the Stainless Steel? (I have the xTOOL D1 Pro 10W, and I did a test of that but did not use ink). 2) On the Tile, are the three layers of paint you apply water-based? 3) Finally, what settings do you think I should apply (Tile), using a 10W laser? Thanks
1.Sculpfun 10W laser can sculpt stainless steel without hacking(9mm/S,100%) 2.If the parameters are accurate, it is enough to spray only a layer of black paint 3.ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-TJ8j2Bbnm6I.html Spray a layer of black paint evenly. Then refer to this video, use the gradient test picture, set the width at least 100mm. The paint is easy to sculpt, so the speed can be faster, and the power is not need too high. You can test the accurate parameters yourself.
It can be cut about 3-5mm, but it is very easy to burn black, which affects the cutting efficiency. But our next generation products can solve this problem.
@@SCULPFUNReal cause I have this model and the kit expansion and I bought to do guitar templates on MDF. Wich parameters you recommend to cut MDF of 5? Thank you
Interesting video....but spoiled by that annoying "rave music" which does nothing to improve it. Why is it used? I just can't see the point. Only kids or teenagers would enjoy this kind of rubbish.