Excellent video. Ive been RC power flying for over 50yrs but only just getting into gliding!! Im just setting up a full house glider setup and your video has helped me a lot ....many thanks 😊
Hey Soren. I really love your videos and tutorials. Here we have a nearly perfect tutorial for DX9 Glider setup. Thanks for that! Only thing i´m missing is setting the offset to 100% (or -100%) in "camber system" to use the full length throttle stick way for crowbrake. In your setup breaks are coming out only from middle to downward. Best wishes from bavaria. A.
Dear SpeedsterDen, dear Soren, a very excellent video which lots and lots of info, which really helps. However, I have a flying wing with 4 flaps and a motor. 1) Can you help me with a set-up for it, in which the motor is on the throttle stick (mode1)? (so as acro??) 2) Can you help me with a set-up in which the ailerons and flaps work together, that is that the flaps go less up/down then the ailerons?
Hello I hope you can help me!!! I have a RES glider ( höllein AndREaS) I want to make setup with my dx9 mode 2 I want...... - throttle on 3pos switch. - rudder controle on aileron stick. - spoiler controle on throtle stick. On witch chanel should I put the two spoiler servo’s. And how do I mix all this in the transmitter? I hope you can/want to help me! Greets Sander
I have many, and most are ok. I have 2 lm0052 with short range but now I just use them as vario/altitude telemetri together with other rx. Spektrum now make some pretty cheap telemetri rx AR6210 -AR8020 and they are great. In most of my small gliders I use the small 6 ch from Lemon.
@@Chorney08 Also here in Denmark, but the new 6610- and 8020 telemetri rx with variometer/altimeter are only around 100- 110 $ here in DK and we can get them in DK
Hej. Jeg har en kanal til hver servo i vingerne (4 stk) og ikke y-kabel. Kan jeg stadig lave samme mix? Jeg er næsten færdig med min svæver til skrænt og termik og flyver i nordjylland. Og tak for den fine video.
Hi Soren, I've also posted this on the Model Flying Forum, where you answered my initial call for help, but in case you don't see it there, here it is again here: Hi Soren, I've been looking through your excellent video.ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-ZgjYSq447Jw.html&app=desktop I was copying your method of mixing ailerons to flaps, when I noticed at 10.08 minutes in, you have flaps set to 47%. But when you push the aileron stick over to the right, the flaps show RF -51%, and -LF 47%. Also, the ailerons show LAL -71%. and RAL -99%. Different percentages each side, both for flaps and ailerons. At neutral, I did notice that your LAL showed 18% On my setting up my own DX9, I find the same situation- different percentages on the left sliders to what I have requested. Just wondered if you are able to clarify what's going on? Thanks, Jim