Тёмный

Square body dash cover install, good and bad 

Z Murray
Подписаться 2 тыс.
Просмотров 18 тыс.
50% 1

1984 Chevrolet square body dash cover install

Развлечения

Опубликовано:

 

14 июл 2020

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 23   
@TOMVUTHEPIMP
@TOMVUTHEPIMP Год назад
You have to remove the old dash cover and foam and they fit perfect. Ive done probably 7 of these.
@zmurray9499
@zmurray9499 Год назад
Yes, that would be replacing the entire dash pad🤷🏼‍♂️ I don’t wanna spend $500 on a dash pad, just the cheap cover.
@carlsegerstrom3989
@carlsegerstrom3989 3 года назад
If you were to do it again, would you buy 3 tubes of clear silicone or use the 3m tape? Looking at doing this for myself...
@zmurray9499
@zmurray9499 3 года назад
2 tubes should do and three 3inch long pieces of double sided tape. I would put them close to the front edge(glass side) pass side, drivers and middle. Be careful because that 3M tape is very sticky. And obviously don’t put the silicone close to the tape. Good luck
@CanadianPenguin_
@CanadianPenguin_ 2 года назад
Do you think it would be easier if you pulled out the dash and attached it outside with clamps instead of weights?
@zmurray9499
@zmurray9499 2 года назад
If you want to tackle that then be my guest. Eventually I’m gonna get a new dash pad. Not now though because it’s very expensive. I don’t think it’s that difficult to get the dash pad off and yes I’m sure that would be better. It’s just kind of a temporary fix And to be perfectly honest this truck does not sit out in the sun and the cover is warping .Good luck
@w9akwqsl
@w9akwqsl 11 месяцев назад
Best way is take a heat gun and take the old dash covering off. And that dash pad will fit perfect.
@terryfrye4552
@terryfrye4552 4 месяца назад
Definitely
@phillipa7595
@phillipa7595 Год назад
Any updates on the cover? I see a year ago you said it doesn’t sit in the sun and it’s already warping..mine doesn’t sit in the sun much but I do not want to have to worry about it lol would you recommend a cover or saving and splurging for the new pad?
@zmurray9499
@zmurray9499 Год назад
Mine hasn’t worked or done anything funny. If you have a show truck then save up and splurge. My truck is not perfect and gets used as a truck. I am happy if the dash is sanitary looking, Not perfect. I’ve never had anybody notice it’s a cover.
@zmurray9499
@zmurray9499 Год назад
Warped!!
@phillipa7595
@phillipa7595 Год назад
Perfect! That’s what I needed! Appreciate it!
@danwilliams8951
@danwilliams8951 Месяц назад
do you have the paint code or name ?
@luismontemayor5713
@luismontemayor5713 Год назад
What kind of glue did you use for it
@zmurray9499
@zmurray9499 Год назад
I believe it was some sort of 3M weatherstrip type adhesive. It was supplied with the cover. I would get two tubes, I would feel better about the install if it had more glue.
@albertomatinez2861
@albertomatinez2861 2 года назад
Dónde puedo ordenar una para México
@Fritter70
@Fritter70 4 года назад
Smurfs seem to take over the siillycone part
@zmurray9499
@zmurray9499 4 года назад
The smurfs have far more patience than I do. Appreciate you watching
@c10gmc
@c10gmc 3 года назад
Hello, this is very nice. Can you give me the purchase link please
@zmurray9499
@zmurray9499 3 года назад
Got it through LMC truck
@tray-oq1nj
@tray-oq1nj 2 года назад
@@zmurray9499 how is it holding up? Do you wish that you would have went ahead and purchased the dashpad replacement kit from LMC?
@enermaxstephens1051
@enermaxstephens1051 9 месяцев назад
I've been all over this squarebody dash situation. Your best possible outcome is to have the factory dash repaired. There is no aftermarket solution that looks good. They all suck. Nobody makes a metal core dash (like factory) which is what is needed. They're all plastic and they're never flat and straight, they're wavy. So if you're reading this, get your factory dash repaired, it's the only way it will look good. A qualified pro can fill in the cracks, then stretch new vinyl over it with no seams. If they say you'll have seams, they're not qualified, so take it to someone else. There's people who can stretch the vinyl with no seams.
@zmurray9499
@zmurray9499 9 месяцев назад
Thanks for the tip👍🏼!! if I was completely restore in this truck then I would go to that extent. My truck is very much driver condition. I just wanted to be sanitary looking. Good to know that there are options. Take care
Далее
Installing TMI Custom Interior in our Square Body C10
16:40
OG Buda - Сделай Мне Приятно Щас
02:24
Square body 4inch lift install
20:05
Просмотров 52 тыс.
Square body seat cover install Tips
18:48
Просмотров 1,1 тыс.
C10 DASH REPAIR EASY DIY   | ROCK AUTO DASH
15:24
Просмотров 38 тыс.
LMC Truck: Chevy/GMC Dash Installation with Kevin Tetz
12:36
Pulling to PERFECTION! | Getting Glassed!
12:56
Просмотров 6 млн
How to install a Coverlay dash cover
3:15
Просмотров 14 тыс.
БАЧОК ПОТИК
0:22
Просмотров 4,3 млн
🚘 когда купил себе полик
0:35
Просмотров 1,7 млн