Step-By-Step Guide to Replacing the Steering Servo in your Arrma 3s BLX 

You most welcome buddy , really happy that I was able to help you . Stay awesome Chris 🤙🤘🚀🛞

No worries at all buddy , i really hope this helped you . Yeah stock ones are not up to much are they . Get one of the servos i installed there brilliant , fast and strong . Thanks for watching Stay safe Chris :)

Thank you buddy 😎

Thanks man , Really grateful of the support , Yeah was going to go out today but it was very very wet to be fair mind . Fingers crossed tomorrow is meant to be dry !!!! Equals Bash time ill make sure i take you guys along for the ride. Stay safe buddy Chris :)

Hey buddy , If you looking for a new servo defo put these on your list . Some of the best servos ive used and very cheap for what they are . This would make hell of a upgrade for you HPI . Hope you guys are safe and well Chris .

Hi Chris What brand are they and where do you get them from. Peter

@@chelmswoodjunction hey 👋 If you check the description of the video there is a link 🖇️ there buddy for the servo . Hope this helps bud . Chris 😎🤙

Hey buddy , Thanks for watching , Right no the loctite is absolutely fine you wont damage anything in fact its always a good idea not bad . Hope this helps ChrisiwithaC

Sorry I mean I mean in your video you put on threadlock to the servo horn but the horn is plastic ?

Hey buddy , sorry for the late reply I’ve been working on going through the comments . Right your now fitting a savox 25 tooth ? I would recommend getting the red servo saver to be honest with you or another idea would be this , ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-Pf2pDAWsmqk.htmlsi=NDhzm-n_NSrghGf2 I did a video on the outcast on how to improve the sloppy steering using a Kimbourgh servo saver . Very easy to do and has held up great so far . As far as putting the stock spring back in roughly put it all back together and then tighten on servo and the screw will turn the spring in worked for me . Hope this helped Stay awesome Chris 🤙💪🚀👊👍🤩

@@ChriswithaCrc oh man that was exactly what video I needed, but I will tell ya that I was able to get that spring in not just once but 3 different times. And I'm pretty sure that the leaning mine is starting to do is due to not being tightened down in place completely. See the servo I have is an avox 30 kg. And it comes with these rubber shims and collar metal tubes that go down through the centers of the shims, but I will say that is a far easier way to access the servo than I was using!!! Man I was getting very frustrated ☺️ okay and by leaning I mean it will when car is turned on steering my start out alignment straight then one hard turn either way and it will get stuck in that line till a hard turn is done the opposite direction. It will vary from 2 degrees or so all the ways up to 5 or more, and was very discouraging because it has been just too much work for a nill result. But I'll tell you there's nothing wrong with the servo. Seems to be high end, and now that I know about this other (ss) servo saver piece I might look into that but also see if it's those 4 mounts that just aren't holding because a small shift there may mean a big affect on my alignment. Thankful for your reply 👍🏻

Brushless and Coreless are the best if your able to get them buddy . Stay awesome Chris :)

I just buy the same servo :) your channel is great thank you