SVC Tire Monitor Fix - 2010-12 Malibu 

Thanks for posting.. I told the mechanic at the shop that my TIRE SENSOR MONITOR light was lit on the dash. He said its most likely a sensor that needs to be replaced... $106 part & Labor! I was able to reset it with the help of this video. Thanks again!!

Always start with the tires inflated to the proper range, that's what I do. Fill them all to say, 35psi. Then SLOWLY let the air out, the sensors are very sensitive, they need to register a change but if you let the air out quickly, it might not catch it. I've had tires filled right out the tire shop doors at 45 so "hey I'll do the relearn by releasing air down to normal" and that hasn't worked 3 out of 3 times! Weird huh? I've done this dozens of times across multiple Chevy vehicles. Fill to 35, let air or slowly for 15-20 seconds, You'll be successful... providing the sensors aren't dead ;) then re-inflate after they're properly programmed, have an air compressor handy or be at a gas station that has air when doing this.

Worked great for me after replacing one sensor on 2011 malibu. Tire shop couldn't reset, but this video did the job. Thanks!

I think you just saved me some money on replacing my tire pressure monitor system (TPMS) on my 2011 Chevrolet HHR after two years of saving money!!! THANK YOU!!!!

Thank you for this video cause that light has been driving me crazy for a while.

I just bought a new (UESD) 2008 Malibu LTZ model and I can say it worked I just did it and took me about 4 mins ... thank you very much !!!

Just had tires rotated, I had the warning, you got me going again. Many thanks!

Thank you for the video. I was able to fix myself. It took about 45 minutes, total. So worth it :)

What if you dont have a key fob

What if your Keyless entry doesn't work - is there another way to start the process

Thanks man very useful and saved me a trip to the mechanic

Wat to do if u don’t have the lock keypad

Is it going to work on chevy malibu 2008?

I don’t have a key fob. How do you make it work without a key fob?

Are you over inflating the tire then letting air out and horn beeping when tire reaches it correct tire pressure?

Thanks a lot. It worked on my 2012 malibu LTZ2

Is there anyway to do this without using your keypad? My lock button is no longer working on the keypad.

So do you need to fill the tires with air first before releasing

Hi there I have 2010 H H R Tire Service comes on few times got 2 new tires front need 2 back my Car Alarm doesn't work apply the same steps that you showed in the video thanks

Thanks...this flashing is driving me nuts.

does this work with a Pontiac g6 2010

What you wanna do is, start by deflating or inflating the tire driver side first. When your car beeps, go to the passengers side & do the same thing. Work your way around the car clockwise. But remember to put the key on the on position and hold the lock n unlock buttons to start the program.

Hello Friend. My Malibu did not detect the left front sensor LF, so I followed the steps of the video, but when something bad happens, I no longer detect any sensor, all the marks in white. Might you help me?? What I can do??

Hey quick question. What happens if the key is on the on/ off position ready to reset in the ignition. Push the unlock and lock buttons at the same time. Even though where the doors are unlocking and locking up. The horn doesn't make a sound.

great video ut when i get to front passenger side, let almost all air out and get 2 beeps of horn. help 2012 chevy malibu

Hello! I tried to follow this video, but when I did the first tire, it honks twice. I tried the second tire but it never did anything. Is that sensor just bad in the first tire? What could be happening? I did it multiple times.

livi N paradise I was wondering I just installed 22's on my car and had this light popped up all I got do is this on my 22's ?

my 2011 chevy malibu loses air pressure on all four tires. I tfilled them up and A week later, the warning lights came on they were low. RF 26 LF 29 Both rears 28. The car had 55,000 miles on it so I took it to get new tires. A week later the lights came on again. So I took it back and they said they put on new valve stems. About a month later, it started again. Tires are low pressure. LF 26 RF 28 RR 28 RL27. I can't believe it. I have to pump up the right front each week for sure. It was on 27 and a week later I went to go to the store and it said it was 22. How can 4 brand new ties with new valve stams lose air on all four tires? I have NEVER had a car do this. I don't drive much but that is still no reason to lose air, day by day when it's garaged. Now it's doing it about every three days I have to pump up the right front tire to 30 psi. It says 30psi but when I googled it just now a lot of sites say a 2011 should be 35psi. I'm lost.

Hey I don't have the original lock keypad I have a viper auto starter will it work with that?

Thank you so much for this video and many blessing to you!⚡️

What if i dont have the remote is there another way to do it ?

Will this work on a 2009 Chevy Malibu? Also, what do you do if you don't have a key fob?

Did the check engine light go away? I'm having the same issue, however I think the sensor in my tire is faulty so I'll probably have to replace it. The check engine light turned on right after I started having those issues.

Mine was saying this first now it's saying service ESC. Can't wait to trade mine off.

I have a 2011 Malibu. When I held the buttons down it didn’t honk but the lights did start blinking. Any suggestions?

Thank you! Worked like a charm. Saved me a trip to the dealer.

Thanks it worked exactly as u said

Thank you for your video. Save me $100 bucks to fix the problem.

What if u have a aftermarket key pad ???

what if you 2 beeps of the horn, does that indicate a bad sensor ?

what if you don't have the key fob? Please tell me there is another way? Do i use the instructions key on the steering wheel?

What is the problem if it wont reset. I went by video which was exultant info.thanks

Usually the second tire shows on monitor but it does beep; is it bad one ??

Great video man Very very helpful Thank you

Once doing this did anyone’s pop back up after you reset? Wanted to know before I try🥺

My 2012 Chevy Malibu ls beeps twice on the third tire then the light for the fourth one never turns on like it did for all the others

nice worked for the left front and rear right but not for right and left rear.

Going to try this tomorrow, hope it works for me!! Thanks for the awesome video. 1 question, Why do you inflate the 2 front tires first then deflate.....Than on the back you just deflate, Please explain?

So what if I do the first tire and it beeps 2 times?

I just put on snow tires, they're all at the proper psi, but my 2010 Malibu will not register it on my dash. Just shows the blank slots. I'm going to try and reset everything by disconnecting the battery and turn the key on and off twice... Then reconnect the battery... hopefully that will clear the alarms and reset the psi readings. We'll see. Is this a normal issue with snow tires?

I did the process and was successful with air pressure at 40, but the SVC Tire Monitor appeared again. Now the LR tire shows the sign - -. All the rest show 40. Did I do something wrong? Do I need to redo the process?

i didnt have to do that. just add air to the tire thats lower than 30 PSI because the average psi for each tires supposed to be at least 30 to 35. once a tire goes lower than 30 the car tells you to they need service. Once all your tires or between 30 snd 35 your gonna notice the service light still comes on. give it a couple of days to let the car realizes the tires been serviced and the light disappears. this happened to me personally . see if it works for you

thanks for this instrucion video help and save money

Is it possible to do without the keyfob ? (Unlock , lock control)

I have a ? I have a 2011 Malibu and the svc light came on but I don't got a remote.would I have to buy a new remote or could I still do the process still

My LR one just wont get recognized

Won't let me do it my key fob says low battery. But brand new any ideas ?

So if it doesn’t work it means I need to replace the sensors I guess?

hi what if you don’t have a key dongle thing

Awesome..but I tried it and at first my front tires and the right rear will honk so i did it again and now only my front tires would honk, I tried it all over again and still..its now showing blank for all the tires on my dash..any help?

I tried this method but remote control didn’t work like in this video

What if i don't have my keyless entry

Thanks works as explained on a 2008 Impala LTZ

My tire sensor monitor has gone off but then my car heats up to the point of overheating. Not sure how there is a link but it's done it twice now. Ideas?

Perfect, great video. thanks!

How did you switch thru the menu at the end Thanks for posting by the way I been trying to get rid of the problem for a while now

What brand sensor did you use?

I followed the video and all tires beeped except for one. All of my pressure monitors are showing a blank line now. What should I do?

so I have this warning now. but it also doesn't read my RR tire. does that mean I have a bad sensor?

It would be cool if just once a trick would work for me any vehicle ever.

Sho you let air out and.put it back in?

Does it’ work on a 2008 Malibu

Thank you, i did the same and every tire did horn at the end the screen shows there is no pressure what should i do ?

Do you gotta do it for the 4 wheels if only one is the one that's messed up?

I think I love you 😍 Was about to waste money on a new sensor smh

What if you don’t have a key fob?

I don't have key less entry

I do not have a key fob what can I do?

What if you don't have keyfob

Thanks this was a big help

use ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-PbmKpCxXYPI.html if you don't have remote. Basically you press the info and reset buttons on left side of steering wheel for one sec. and it will go to another menu, scroll to tire learn and press enter then proceed as Livi'N'Paradise has so kindly shown to clear code and relearn each sensor for location. I has same issue pop up when replacing dead battery. Hope this helps. I would suggest checking out the other clip I have in this comment for starting the process. Both very helpful and don't forget to subscribe to help Livi'N'Paradise. Thanks to everyone who posts these helpful videos!!

Tried it on a 2011 Malibu. I was really hoping it would work, because I had only one sensor not reading after a tire patch. I tried it 3 times and now all the sensors are reading blank " -- ". Any suggestions?

I have the key pad but when I hold it down the car never honks, why is that?

Will this work on my 15 malibu

My 2009 HHR dopes not have a keypad (remote). What do i do?

Não existe esse vídeo em português?

What if you key lock button doesn't work on your car anymore

Teria como traduzir esse vídeo.

Will this work for a 09?

Quantas libras de ar seria o correto para o pneu aro 18?

The other one said let air out. I give up

What about if your remote don't work ?

what if you only have a manual key

Thanks Worked :)

It came back.

okay I do not have keypad so how would I access the dash board? I too am trying to get mine off

This sweet as fuck I'm going to do it today thank you so much for your video

Can't get it to honk twice at the beginning

Thank you. It worked with me.

Sad didn’t work for me but then again maybe doing it wrong