Thank you / Your video is the best / I was almost sending my drone back / Your video changed everything , and I lost the fear because so many people lost and not knowing what to do . Once more thank you / I wish successes for you .
that is the IMU calibration - make sure the drone is on a flat surface before you start calibrating. If that doesn't work, check that your joysticks are not out of alignment (can be changed using the little silver switches beside each joystick)
Fantastic video. When you restart your drone and then the controller, do you separately shut down and power back on the drone before you do the same with the controller?
I just got my df1 I only did step 3 and I couldn’t control the drone the battery was also low out of the box and the drone crash landing on the way back home. Also the battery is now swollen before my fist charge
Hi mate. What could be possible causes of no gps signal on controller. Always shows 0. I believe the green gps wire on receiver is secure & have tried a few different things but still 0 showing for gps signal. Cheers mate
hi, sorry for the delay in reply, you might want to check the cable to the FD1 - sometimes when this is pulled a little by taking the lid on and off - it can mean that the connection to the lid and gps aren't good. Thats one possible reason.
Hello, after the horizontal and vertical calibration the two fixed red lights stay on and the 2 green lights blink quickly. The manual says what is the calibration?
Hi, I have a question after you do the 1st check the IMU left joystick up and left right left etc.. on the other joystick wait for the initializing to disappear, do you then power drone and controller down the power back up.
