Тёмный
No video :(

Symptoms of a Bad Idle Air Control Valve (IAC) 

HVAC Mechanic
Подписаться 65 тыс.
Просмотров 69 тыс.
50% 1

Common symptoms of a bad Idle Air Control Valve (IAC) and how to fix it. Read here for more information: www.backyardme...
An Idle Air Control (IAC) valve is controlled by the computer and allows air to bypass the throttle body butterfly plate.
Some Newer vehicles don't use an IAC but have an Electronic Throttle Body (ETB) System, which controls the throttle butterfly plate.
A bad Idle Air Control will only affect the idle of the engine, but engine will run well when the gas pedal is pressed.
Symptoms of a Bad Idle Air Control Valve
Idle Speed Erratic
Idle Speed Too High
Idle Speed Too Low (Stalling)
DTC Error Codes (P0505 to P0509)
How To Fix a Bad Idle Air Control Valve
An intake air leak can cause the same symptoms as a bad IAC since it is letting air in around the throttle body.
The most common fix is to clean the IAC of carbon build-up, but it may also have failed or have a wiring issue.
If the IAC is cleaned, the engine may run badly for 2-3 minutes until the cleaner is burnt away.
By using this information user assumes all risk of use.

Опубликовано:

 

30 окт 2023

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 43   
@vincentbryan1962
@vincentbryan1962 5 месяцев назад
Thank you for making this video. I drove 30 miles with bad IAC. Ended up not hitting a single red light so I had my foot on the gas the whole way.
@carriersignal
@carriersignal 3 месяца назад
Wow. This is a very good video. My car is exhibiting the very symptoms you describe. It runs fine going down the highway, but as soon as your press the clutch in, its RPMs drop and it stalls out. It also seems to occasionally idle at a very high or sometimes erratic RPM. It has been setting for a while in the garage. This will be the first thing I take a look at along with any air leaks. Thank you!
@joey3032
@joey3032 26 дней назад
2006 dodge Durango 5.7 hemi v8. 115,000 got it 4,000 less. Stalling on low idle/ traffic lights, especially when making turns that doesn’t require giving gas ( or throttle) I can wrench a bit and have replaced, recently enough quite a bit of the exhaust system in general still bad ass truck. Cat delete Too many minor fixes replacing and cleaning to list but appreciate this video bc it’s helping me to narrow down before I get too crazy trying to get the air fuel ratio tuned. She was slightly neglected but still a beast. Thanks this helped tons. I would appreciate a response from anyone and I can elaborate further as I fix
@johnmcnulty6392
@johnmcnulty6392 Месяц назад
Great Video! I have a 2006 Jeep Grand Cherokee and recently put new heads on due to bad head gasket, also new timing chain kit along with brand new OEM catalytic converters. When i was taking the Cruise cabe off the throttle body i broke the nub that the cable clipped to so i got a used throttle body and rebuilt mine. The issue i'm having is sporadic idling and when going down the road i have to mash the accelerator to get it going. Stops are worse trying to get going. I have replaced the IAC and that did nothing , The data on my scanner is saying the IAC has high input voltage. I was told with me rebuilding that throttle body it is probably out of spec, So i ordered a new throttle body with both new sensors IAC and TPS . I installed the New throttle body last night and its still the same running ruff and still have High voltage at IAC. Can anyone lead me too what might be causing this High voltage? I can't find anything besides replacing the IAC. Instructions with the NEW Throttle body say's the IAC needs Idle speed relearn and i cant find anything for my jeep how to do this. Also as last night im throwing a code of UO41, Witch i just watched your video on that before writing this book. Thanks for that as well. Any help would be appreciated. Thanks
@georgehooper6955
@georgehooper6955 9 месяцев назад
Great video and explanations! Nice and direct
@kalpeshkapadia4623
@kalpeshkapadia4623 3 дня назад
Thanks sir
@Hardwick989
@Hardwick989 3 месяца назад
Its the same issue with mates Toyota hilux. Prob mid 80's. Trayback . I pulled it off and cleaned it. Good for 2 days then back to over reving, about 2100. It is the idle sensor, electric that controls a magnet i think to turn the shaft inside. Ive minipulated the shaft and confirms its faulty. But only the magnet! End where it has a elec plug.
@Jaybaby153
@Jaybaby153 Месяц назад
Good video, well done sir!! I subscribed to ya!!
@kamalmahmood406
@kamalmahmood406 4 месяца назад
Great video, thanks. How do I differentiate between malfunctioning Idle air contole valve and leaking air please?
@jakub4976
@jakub4976 4 месяца назад
Try feeding smoke in the Intake. While it is running. The vacuum lean should reveal itself w smoke if you have a vacuum leak
@davepatt6018
@davepatt6018 3 месяца назад
Thank you bro that's good information to know
@LightoMusica
@LightoMusica 8 дней назад
I have a creta 2017 which doesn't start unless I push the gas paddle. Rarely stalls 2-3 min after start and it's usually when stopped at traffic lights. The throttle was cleaned, changed sparks and air filter, still the issue remains (no error codes). It happens when the car is parked for like +8hours. What could be the issue?
@adamc4155
@adamc4155 4 месяца назад
Have all the symptoms, but the engine code is a misfire p0300 code and a misfire code for all cylinders.. already checked all the usual culprits, the iac and egr are among the last to check besides possible vaccuum leak..
@proroofersncllc-vb8rl
@proroofersncllc-vb8rl 2 месяца назад
I had same code my issue was water in the gas tank, dumped pit new gas on it and truck runs again.
@adamc4155
@adamc4155 2 месяца назад
@@proroofersncllc-vb8rl might have to do that.. it's either that or the ecu is burnt out
@ricardogonzalez3032
@ricardogonzalez3032 2 месяца назад
2016 cryshler 200 2.4 once you have it in reverse engine stalls,replace motor mount.transmission mount same thing did tuneup spark plugs coils,pcv,clean throttle body
@moviegoer9021
@moviegoer9021 22 дня назад
MY 2004 TOWN CAR,STARTED TIS RECENTLY,I HAD CHANGE THE IACV A FEW MONTHS AGO,FOR A NISE COMING FORM MY AIR BOX,VIBRATING,HIGH PITCHED NOISE,CHANGEIT,WENT AWAY,NOW THE FAST IDLE AT COLD START,NO LONGER HAPPENS,JUST VERY LOW IDE,I HAVE TO PEDAL TO KEEP RUNNING,AFTER WARMING UP,DOES BETTER,STILL A LITTLE MISS FEELING,BUT RUNS GOOD WHILE DRIVING,SHOULD I CHANGE THE IDLE AIR CONTROL VALVE AGAIN? I DID BUY FROM E-BAY,IT WAS CHEAPER,WAY CHEAPER,THANKS,APPRECIATE YOUR THOUGHTS ON THIS, I GET NO CODES OR ENGINE LIGHT,CLEANED THE THOTTLR BODY AND THE MAF SENOR, NOT MUCH CHANGE AND STILL NO ATOUMATIC HIGHER IDLE AT COLD START.
@Sensei_is_dead
@Sensei_is_dead 7 месяцев назад
Thank you
@johnf.6942
@johnf.6942 7 месяцев назад
Good video! I have a 2015 Nissan rogue, runs great first 10 minutes or so , but vibration starts and is present at stops, and at idle. I Cleaned up throttle body, mass airflow sensor, new filter, new pvc , no cracks in any hoses, new engine mounts, new 02 sensor, pre cat, no codes, fuel cleaner in , fuel trims are good … …🤔.. any thoughts?
@21gonza21
@21gonza21 5 месяцев назад
Does it suppose to leak or vacuum air thru the idle control valve ? I did a smoke test and smoke came out of the control valve
@jifcks4320
@jifcks4320 5 месяцев назад
What happen if the iacv hose line has tiny leak ?
@swimwithcoachraven1532
@swimwithcoachraven1532 4 месяца назад
Mine didn’t have a cel when idling as soon as I hit high rpm the cel comes on. Now it comes on as soon as I start the engine. It’s just got worse
@franzapolski8863
@franzapolski8863 8 месяцев назад
Hi, my name is Fran I have a 2008 Saturn Arua XR 3.6 with Idle problems changed the throttle body and checked for a vacuum leak checked some wiring still the same problem. What's next? Changed the throttle body because had a low-speed warning light.
@user-uw7gf4xp4n
@user-uw7gf4xp4n 6 месяцев назад
Mine does those things but also after it's warmed up when I put it in gear it dirs
@michaelvazquez9625
@michaelvazquez9625 Месяц назад
So i was getting shaking when idling so i cleaned my throttle body and put in a new aic valve and my problems started. Was the new one i put in faulty? I bought it at autozone. Should I go and demand another one?
@HVAC_Mechanic
@HVAC_Mechanic Месяц назад
Some vehicles have what called a Throttle Body Relearn. If the parts and wiring is good, I would research if it needs a throttle Relearn.
@johnfink9020
@johnfink9020 Месяц назад
Unhook bat, set for 30 mins. Hook bat up, let idle for 10mins.
@tracemiller1519
@tracemiller1519 2 месяца назад
I’m having the idle problems bad but I’m having codes like p052c cold start and other codes like camshaft/crankshaft correlation sensor and timing codes, could the AIC or throttle body cause such things??
@HVAC_Mechanic
@HVAC_Mechanic 2 месяца назад
It will need to be troubleshooted, but that sounds like a timing issue such as a slipped timing chain/belt.
@markanthonybokeron1860
@markanthonybokeron1860 Месяц назад
Hey bro. My car is 2006 honda civic coupe 1.8… does it have an IAC valve or its called purge solenoid valve??…coz i cleaned my throttle body using cr throttle body cleaner. After that the idle is too high and fluctuating and the engine light turns on. I reset it manually by gaking the negative wire on the battery. and by the way i scanned it and the code is po505 .. doni have to replace the purge valve that is attached to the throttle body???
@HVAC_Mechanic
@HVAC_Mechanic Месяц назад
The purge valve is for the EVAP system used for emissions, which is separate from the throttle body idle. If the purge valve is bad, it will usually give an EVAP code. With a P0505 code, there is still an issue with the throttle body. Usually, it is dirty and needs cleaning, or a component has failed, but it needs to be troubleshooted.
@robbiegoldfinch8137
@robbiegoldfinch8137 7 месяцев назад
What if when you step on the gas and it puts
@lynskyrd78
@lynskyrd78 2 месяца назад
I hate that....
@nony350
@nony350 4 месяца назад
What about the engine nice and hot and push on the pedal while in park an it idles high like 3 rpm’s then after 10 sec or so it starts to idle down to normal is that a sign of bad iac too ?? Code shows p0507
@HVAC_Mechanic
@HVAC_Mechanic 4 месяца назад
I made a video on a P0507 code. Here is a link ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-EmP0yDshwIc.html
@juliansdiamonds
@juliansdiamonds 7 месяцев назад
Great thank you
@dfields9511
@dfields9511 8 месяцев назад
IAC vs bad TPS thought ?
@thabisotee897
@thabisotee897 8 месяцев назад
My toyota stalls while am driving up a hill
@WaltuhBottlecap
@WaltuhBottlecap Месяц назад
Og ghost cam
@intelin123
@intelin123 5 месяцев назад
Fuel pump
@Jimnymudhunter
@Jimnymudhunter 2 месяца назад
Every time he says "idle air control valve" take a shot! 🫣🤣
@traktor321
@traktor321 2 месяца назад
🤣🍺IDLE🍺AIR🍺CONTROL🍺VALVE🍺🤣
@MrDavion58
@MrDavion58 Месяц назад
No way I can work on my car now. 😂
Далее
SYMPTOMS OF A BAD THROTTLE BODY
2:59
Просмотров 582 тыс.
Top 5 Common Symptoms of a Bad Idle Air Control Valve
5:25
How to Fix a Car that Idles Poorly (Rough Idle)
13:52
17 symptoms of a bad mass air flow MAF sensor
5:12
Просмотров 275 тыс.
TechTips #1 - Electronic Throttle Body Troubleshooting
13:53
Top 11 Symptoms of Bad PCV Valve
6:24
Просмотров 502 тыс.
SYMPTOMS Of A BAD AND FAILING IDLE AIR CONTROL VALVE
4:36