How do you fix the VFAS increments on the X9D+? On my 1s quad it just jumps from 3.81v to 3.62v to 3.43v to 3.2v or something. It's not accurate at all. If voltage is at 3.6v then it will show 3.43v the whole time for example. It just shows those few increments. On my x-lite it actually shows the voltage to the 100th of a volt. Example 3.61v, 3.60v, 3.59v, 3.58v all the way down nicely.
Thanks for this great video, I've set this up on my TX16S and it's working well. Would you perhaps know how to disable the default RX battery warnings, as I now have both warnings?
Check my Zorro video. It's basically the same on a TX16S to set the voltages and warnings ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-IFvLQy3KrKs.html
Master Taranis !One of the best Videos of Taranis i have seen. I have upgrade my radio and not showing VFAS, WICH ONE is the new name for VFAS ?On Radio? Thanks a Lot ! Greetings from Peru
I suppose you could do the same with cell voltage instead of VFAS that way if you use 3,4,or 5s batteries, it would have the same warnings. thanks for the vids. :)
You can put this on anything - RC quad, plane, boat, car. You need a flight controller that has a voltage sensor, supporting firmware and a receiver that supports telemetry.
I also calibrated my vfas sensors . The F4 was perfect , but the F7 flight controller was 0.2 off . I was surprise. as the f4 is a clone and the F7 was by holybro . $$$$$$.,
Excellent explanation of logical switches! Would you be able to assist with setting up a special function of? IF [throttle value]>[min throttle] AND [idle up switch] is not activated THEN overwrite [arm switch value] to [disarmed]
It’s for the Mr.Steele idle up setup he uses that I setup on my taranis but I would like to add this feature to prevent enabling idleup with the throttle potentially set to mid position and causing the quad to arm and take off:)
Followed your tutorial. Very clear instructions. Then I spent next 2 hours trying to figure out why it wasn't working for me. Turns out that I didn't have the sound pack downloaded onto a SD card. Anyone wondering why there is no sound. Make sure you have the sound pack downloaded from open TX. still a great tutorial tho. Thank you.
Very good video and easy to follow, you set the logical switch "AND" function to be used with a switch could a throttle value be used for example the battery "condition" alarms will only sound when throttle is above -100
Nice video mate! Helped me a lot to understand what's possible with the Taranis. Added L03|a>x|Throttle|-95 on L01 and L02 chaned switch to L03. Useful for Planes.
The font is part of the OpenTX build options. Just select the font in the OpenTX Companion Here's how ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-FdtBDMRb7kg.html
These are the ones I use www.circuitspecialists.eu/power-supplies/bench-power-supplies/ They very reasonably proced in the UK, but no idea about Denmark.
Ty for advice.I can buy those here too i see.- circuitspecialists.glopal.com/da-DK/p-174/adjustable-dc-regulated-linear-power-supply-csi-1802x.html?.circuitspecialists.eu&GB
