Technically Speaking EP1: Mitsubishi Electrical Troubleshooting 

Thanks for this video, I haven't worked with this kind of A/C but it's good to learn something new and so important . From Venezuela. 🇻🇪👏🙋‍♂️

thank you for this video it made me call a repair tech within 4 minutes of watching because i realized i have no chance of doing this with my cute little pink tool set from home depot lol

Great video and thank you very much, I typically work on the water source heat pump’s and I do have experience installing Dr. splits but I’ve never had to service one,,, this video has given me a great first step in troubleshooting☝️🙏🏾🙏🏾🙏🏾🍺

That was a great training video great job

wires crossed where? Are you going to do a video where you fix the issue?

Very good video on troubleshooting. Very helpful.

Thank you, very helpful.

Good video. Very helpful

How about Mitsubishi split unit blinking 14 times?

Fujitsu use a diode on black lead to show a steady voltage on 3 or signal wire

Very thorough

Great video, very informative.

Is that reading method the same for all inverter mini splits?

If you lose one leg coming into the unit would that cause damage to the unit or do they protect themself?

Thank you, again. I have watched it the second time. Zone 1, OU (outdoor unit) has identified a problem with the indoor PCB. The OU is giving a steady voltage between S2 and S3 and should fluctuate on DCV. This means that the indoor PCB needs replaced. On Zone 2, S2 to S3 is fluctuating in AC at low voltage. We should have a steady 210V. DC should be fluctuating between 12 and 26V at S2 to S3 but it is fluctuating at AC high voltage instead. That is an indicative that a short or a cross in the wiring. Is the PCB of OU faulty, as well?

Thanks for the video =)

Hello I would like some one tell me where I can get mini slips troubleshooting please

is this training from trane mitsubishi hvac classes on their website?

HI How to check for inverter compressor voltage? What is the minimum voltage for the compressor to opreate

Why not remove signal wire at outdoor unit and measure out there

Hello Sir, Is it possible to add reverse valve in the inverter ac's. The ac is of R32 gas and 2.2 ton.. Mitsubishi electric GR series model

Does anyone know if this is fairly standard across brands? (Mitsubishi, Daikin, Fujitsu, etc?) In my limited experience with them (almost exclusively installation), they appear to be wired in much the same way but I have no idea in the differences of board function

Where is the video that tells you what it means if both indoor and outdoor units have non fluctuating DC current between s2 s3

Thank you. Where can I find EP2, the continuation of this?

To connect without board

What if I have power coming to the outdoor circuit board but none leaving to the indoor units?

Anyone else notice the suction line freezing?

Wapp nu plzzz sir