The Trick To Remove Banshee Crank Bearings 

excelente, gracias por enseñar el proceso

Hi cheers from Puerto Rico nice job

Was riding today when I heard some nasty noises, and the engine wasn’t running right. Down on power, sluggish down low, popping and cutting out in mid range. Went back to my truck to swap plugs but then it wouldn’t start at all afterwards. So I pulled the flywheel cover and kicked the starter a few times. All sorts of wobbly flywheel movements! I can move the flywheel up and down by hand 😭 I’m sure the bearing(s) are shot. Probably only 20-30 hours on this crank. I might try this to revive it!! Tempted to get a 4mil stroker kit tho too

My banshee has a slight growl that started after a ride, still runs fine, would it make sense to just put new crank bearings on? Or should I replace the whole crank?

nice. i done had new cranks where the seals that go over the crank bearings in the middle rip apart and they sell the seals but no way on how to get them back on. ever run into that problem?

You're half way done, there's two more!

Do you have to use feeler gauge to see if its properly balanced after install or no?