My neighbor just brought this 2021 Kawasaki Brute Force 300 in. It's not moving very well acts like the belt is slipping. This could be a common problem. Let's check it out and fix it. Thanks For Watching.
i have a tracker 300 all the 300s between acticat, tracker and kawasaki are the same bike just hit 3200 miles and this started happening i sent mine to a shop and had it repaired for decently cheap
Once u cook a seal. And the clutch gets soaked. With oil. U cant save it. A new seal and a new clutch. Is the only way. Kinda like a drum brake on a car when the shoes get contaminated with a leaky wheel cylinder. Or a leaky axle seal. Good vid. Thank you.
My 2020 Brute Force 300 has done this exact thing. I took it apart and it all looks the exact same, oil leaking, shaft in too far etc. Do you know what ended up being the root of the issue?
It wasn't easy with the belt on the back pulley I held the belt as far forward as I could and started the front pulley on a little with the bolt then rotated it to work the belt up onto the center sleeve of the pulley and kept tightening the bolt and rotating the pulley.
It wasn't easy with the belt on the back pulley I held the belt as far forward as I could and started the front pulley on a little with the bolt then rotated it to work the belt up onto the center sleeve of the pulley and kept tightening the bolt and rotating the pulley.
It was pretty low mileage only about 400. The neighbor said they buried the atv in the mud pretty deep and was trying to get out then after they pulled it out it seemed to be slipping. The only thing I can think of was the over torquing of the clutch trying to get it out walked the shaft in or because of heat. Strange but I've seen some other posts on forums about the driven clutch oil seal going bad I wonder if it's the same problem happening.
@@TheGoldenHillFarm There is metal plate with screw that uses as bearing retainer from inside and circlip on shaft just behind the seal that was leaking. Must be one of those two things that failed so shaft will probably go in again. It needs to be inspected further and warranty should cover it.
