Moped Rich it’s okay! This video was super helpful and included much more instructions than a typical how too. Thanks for teaching me how to swap and reline my clutch pads!
Hey Rich how have these pads been holding up and have you found an alternative to the glue or heard of an alternative to the glue? I've heard of people using JB weld Marine epoxy.
@@MopedRich Okay well thank you for your quick reply. I love your channel and I also watch Travis tutorials moped problems and I was referred to this video from CornPed
It depends on certain variables. As far as miles go on a stock setup with an exhaust only, these are still running. I have a customer who rides his Tomos every day and the clutch pads are still working. He has put hundreds of miles on them since and it's been about 9 months or more since I did his.
is it the 1st, 2nd, or both slipping? If it's 1st, then it might be the bearings behind the kick start cog. I would have to find a picture of it. Had this happen to the bike I was working on when I made this video. I thought it was the clutches and after re-ligning them in these videos, it still slipped. I kept tinkering with it then I found out it was those bearings that were not catching and making the 1st gear engage, the bike would only engage on 2nd gear. This would make the take-off extremely slow until that 2nd gear hit.
If you are using original clutch pads in a kitted bike odds are they will be eaten out easily, my 1st gear was powerfull until i put a 70cc and now 1st slips, bought new cork pads, still havent installed em tho
