Toyota MR2 Roadster Malian Muffler fitting 

You’re most welcome 🙏

The drone was really irritating and got worse with speed, i sold it on ebay after a couple of years to get my sanity back

@@andrewsparey697 OK...thanks for the info! Too bad because it seems to sound pretty good, but I don't need *another* car with drone.

I would estimate the Malian is 5kg lighter

No baffle rattle , but i have to admit it does drone a lot when the engine is under load , say uphill. If i did it again i would get the TTE style with the two exhaust at opposite ends of the bumper

@@andrewsparey697 thanks for the heads up, gotta give this some more thought

@@dawtsmr8502 this one is what i would try if i did it again www.ebay.co.uk/itm/Toyota-MR2-Mk3-Spyder-1-8-TTE-Catback-Performance-Exhaust-System-/264065372533?_trksid=p2349624.m46890.l49286

@@andrewsparey697 ye I was looking at that one too, seems like a decent platform for a bumper-exit conversion as well. The lotus style one really looks nice tho, but need to be able live with it since I daily my spyder 😉

Nope, not sorted. Put all original exhaust system back on , new sensors and still failed mot

@@andrewsparey697 Strange,seeing as everything is replaced back to original. Only other thing you changed was the post cat lambda,it might be worth getting a multimeter and checking its voltage (a lot of cheaper o2 sensors are of questionable quality). Been following your videos,hoping to get myself a MR2 after xmas as a summer plaything/runaround,i was looking at MX5s but the rust on most of them is horrendous.

@@joe10toes ill sell you mine if i can get it passed an MOT

Probably requires a REMAP to achieve emissions requirement

Not specifically but they were pretty long. No less than 30mm

@@andrewsparey697 nice one, thanks for getting back to me

I have had it installed with my factory mid pipe cat, no interference in my case

Andrew Sparey My Malian has a bell mouth fitting for some reason and that is why they are so close. I’ve bashed the heat shield back a bit and they now are tight together and don’t rattle. I think I’ll stick with this

@@stuartrobson4331 i have actually thrown all of my heat shields away one by one, most dont do anything but add weight, with the exception of the one that protects the air filter box which is important- until you throw away the air box like i have

I did not but it was so massive it was not worth comparing. The Mallian was half or perhaps more than half than OEM

@@andrewsparey697 cool thanks for the quick reply. Been watching a few of your videos. Very helpful. Did it improve your drive at all? And was it just noisy underload and ok for normal driving?

@@MeltonAngling it is insanely noisy , to a point of distraction. It makes me careful with my acceleration , lest i get pulled over

@@andrewsparey697 oh dear. I guess that wont be for my daily use then. Thanks for your replies, keep up the good work.

@@MeltonAngling get the TTS style where there is a dual exhaust, one at each end of the bumper. These seem to be substantially quieter

Yeap, very loud and touches the bumper. The TTE exhaust style would be superior

Sounds great to me, but does look like not a great fit, and might be too loud for daily/highway use.