Toyota Sequoia Alternator upgrade - 2JZ

Подписаться 708

Просмотров 2,1 тыс.

50% 1

Upgraded the alternator on the mk3 supra from the factory alternator to Toyota sequoia. Highly recommend taking the alternator to a machine shop to trim down the excessive material. Make sure that you take the 2JZ alternator for measurements to get the machine cut right.
Factory 2JZ -90 amps
Toyota sequoia - 150 amps
Part # 27060-0F050
Total Power Parts Compatible with/Replacement For 400-52686R Alternator 4.7L Toyota Sequoia 2003-2009 27060-0F050, 27060-0F110 a.co/d/811QE58
PHR alternator harness
www.powerhouse...

Опубликовано:

16 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 8

@ahmedcool5004 7 месяцев назад

I like your car so much ❤

@Fonzgarage 7 месяцев назад

Thank you!

@traingeek2000 Год назад

I did a very similar upgrade using an early LS430 alternator, 140A and uses the same 3-pin connector as the 2JZ; no adapter needed. I just hope I didn't take too much off the mount and belt alignment is okay.

@Fonzgarage Год назад

I didn’t know LS430 works too, I highly recommend taking it to machine shop for this type of work. I just took it for a drive and did some 25+ psi boost pulls and it held up pretty good!

@traingeek2000 Год назад

Did you also swap out the alternator fuse?

@Fonzgarage Год назад

Hey I did not swap out the alternate fuse

@TheBRPredator Год назад

Do you have to upgrade the alternator pulley on these when over revving? Heard of a few 2js blowing up the factory alternator when revving over 7500 rpm

@Fonzgarage Год назад

I did not upgrade the pulley at all. I haven’t heard any blowing at all. I’ve done good amount of 8k pulls and so far so good! Just gotta make sure you have a machined down correctly. If it’s off, I am sure you will have problems and that’s what many people having issues cause they don’t machine is correctly