Toyota Venza rear knuckle replacement (with commentaries) 

Thanks. That was very informative. I like the way you clearly explain the different steps.

Thanks so much for this. I followed your video and was able to complete the job in my driveway. Very clear and easy to follow instructions. I got lucky with the ABS sensor and was able to remove it. My tip there is to disassemble until you can access the sensor port from the inside of the knuckle and soak it from both sides with penetrating oil. Was not so lucky with the bolts as I did have to cut them just as you indicated. Love your accent by the way.

Thanks for the video,I am in the process of doing both of the rear knuckles,most of the bolts are sized in there,so it's a pain ,the knuckles can be found on e bay complete with bushings

this bushing can be replace by Febest TAB-166Z.

Nice job. How hard is it to disconnect the driver's side ABS sensor and pull the wire to do the same retrieval from the existing knuckle?

There is no need to remove the rear seat to disconnect those abs sensors. If you're replacing them, cut them, and disconnect it from the plug via the long vertical panels next to the seat. When reinstalling the new ones, pry open the rear plastic panels behind the seat so you can push the abs cable foward to be able to reconnect. Did this last week. I believe removing the rear seat completely is a waste of time.