Transfer Pump w/Honda GX 200 Engine: Only Runs When Choke is on Full

Подписаться 5 тыс.

Просмотров 6 тыс.

50% 1

Thank you for watching! If you enjoyed the video, or found it useful, feel free to like the video and subscribe for more content! I recently launched my merchandise shop! The quality of the merchandise is great and the designs look amazing! Feel free to check them out! All support is greatly appreciated :)
L&M Store Link: landmrepair.my...

Опубликовано:

28 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 15

@mongrel1799 Год назад

good pace on the video, easy to follow. I'm in the same camp, only running with choke partially engaged. Pulled the carb and cleaned things up, but the main jet is "welded" in and won't come loose. I ran a copper wire strand up there and it looks like decent flow... I'll button it up tomorrow and see what's what. Thanks!

@mikebuckley5740 3 месяца назад

The spring is to keep the throttle rod tight

@jonlambshead5115 Год назад

I Hate Those Stupid Plastic Idle Screws , They Cross Thread If Your Not Careful & They Break Off As Well. Other Then That , I Love Honda Motors. So Easy To Rebuild, Parts Are Cheap & They Last For Ever, If You Look After Them Properly With Oil Changes ETC

@Newfiestang50 11 месяцев назад

surface of engine between carb and engine looked pretty dirty. And not sure but didnt see a gasket there. surprised you never inspected that.

@lmsmallenginerepair4471 10 месяцев назад

there was a gasket

@carlodonnell146 Год назад

Hi L and M, A question for ya! Why would a new exhaust muffler on the gx200 cause back fires and rough running. I replaced the exhaust on my gx200 honda and it back fired badly and loud/rough. I ended up putting back on the old one. The new muffler is a little smaller than the old one, would that cause it?

@lmsmallenginerepair4471 9 месяцев назад

yes

@JesseGreer-f2y 7 месяцев назад

You'll have to rejet it.

@sootie620 3 месяца назад

Your a bit like myself in the hands department, whitewash brushes, not easy for the small components 😜😎

@lmsmallenginerepair4471 3 месяца назад

Very true!

@laurianopaniagua3825 8 месяцев назад

I have a Honda gx160 when i start it, it starts good when i go to move the choke back down it accelerates to the max, instead of it staying stable. Can you give me an idea what it could be. Thanks

@lmsmallenginerepair4471 8 месяцев назад

is the throdle stuck on the carb

@carlodonnell146 Год назад

If the fill hole is opened too, it may drain faster. I wish the gas-tank had a drain plug. Are you suppose to drain the tank through the carburettor?

@lmsmallenginerepair4471 9 месяцев назад

yes or just take off the fuel line