Tre Spade MEAT GRINDER MINCER No #22 Motorised meat grinder - powered 

What a great way to repurpose the motor and gear box. Thank u kindly for the video. Cheers 👍

Awesome mate I came here looking if anyone else had the idea Id be surprised if someone doesn’t make a compact unit idea with an old style grinder perhaps with ceramic coated grinding plates to eliminate oxidation etc I’m sure if someone brought out a small compact unit it would sell very well as you can do mashed potatoes purée the lust is endless of the uses and I swear pasties I’ve had with ground meat from a hand grinder tastes better and more fluffy and and light than most pasties you buy today !!!

Perfect

just great idea ching ! thanks from usa.

Awesome how that nifty drive coupling worked out huh! lol Sweet! One piece of advice, take it or leave it. When you slide the components together you shouldn't have to lift one side or the other for the fit. If you do, make the necessary adjustments with shims so the alignment is as close as possible. It'll save your bearings from premature failure. Could be part of the cause of motor noise under the load also? Still, nice work brother!

nice

For the long term look into a jaw coupler. They cut down on bearing wear.

спасибо за видео.

Overload insurance?

Nice job. I'm looking for a mincer at the moment and your videos are swaying me towards this Tre Spade 22, but I'm trying to determine if just the stainless No8 is enough for me. Funny you mentioned it's whitworth as that that is the standard my old Myford lathes use! Wouldn't have to faff as much to make a drive bolt! I know it's been 3/4 of year, but some ideas for motorising. If you mount the motor below, you could use pulleys and belt drive it. Would make it easier to dismantle to clean, use less counter-top space and give you some height to drop into a bowl. Secondly, get some nice stainless dowels the right size for the mounting holes and if they were tall enough and set deep enough into the mincer's wooden base, the mincer can't twist it's way out. Simple as dropping it on or pulling it off! Any minor give/twist from the torque should be safe due to a pulley and belt.

bravo messieurs dommage que ce n'est pas sous titrés car je comprends pas l'anglais mais avec la vidéo ça vas merci

Any chance the bolt head attached to the worm would snap? Would need a screw extractor just in case.

Great video !! Would a lift motor with a speed of 32.8 feet per minute be too fast? Or would that work do you think? Thanks !!

Mcm.mana kalau mau order ni

Please, how much?

Hey. Do you think this motor would be able to mince a fish frame?

Motor kac kw rodüktor kac d/d

Boa noite da pra moer carcaça de frango?

سلام

سلام خوي

Rpm for gear motor

If it work's who gives a crap about the aesthetic look. Lol.

Innovative use of the motor and your coupling method was a bit of luck and genius. I did this with a Porkert and used a higher speed, @ 150 rpm's. Here is a test run: ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-asCPLzvwK4Y.html

Monsieur s'il te plaît. Je peux vie midi moi. Je demande à référence de menteur. Plus aviateur de vitesse

Karabakh is Azerbaijan 🇦🇿🇦🇿🇦🇿

Fai troppe chiacchiere e non fai vedere quello che dovresti