Trident V2 clone by Ehpro 

It ran me $18 and the build quality is really good. I still use it heavily.

i like the trident v1 clone so i went ahead and got this one too.. nice review man.

hi, did the ring for the air hole came with large enough holes to fit all the air holes in the top cap? or you had to drill them out? thanks in advance.,and nice videos., keep them coming.,

Nice job on the review and build. I have one of these and am wondering if you have noticed that the air holes on the AFC ring are actually smaller than the largest air hole that's on the top cap. I don't get that. I believe, in single coil mode, the largest air hole on the top cap is 3mm but the air holes in the AFC ring itself are only like 2mm or 2.5mm. Is yours like that?

The Russian seems to be the only clone to successfully improve on what it's copying. The holes in the v2 ring seem to be 2mm. I'm surprised by that but have no issue with lung hits. I just had to try it wide open side by side with the v1 to see a difference and it is a tad tighter but can't say I would habe noticed if I wasn't looking for it.

How much did it run you? Also, is the build quality even as Good?

No it did not. I don't know why they did that but like the real one the largest hole is bigger than the holes on the ring.

what watts do you use on a o.50ohm?