Typical Wall Junctions 

Thanks James, Glad you like them!

Hi Mate, thanks for your comment, I hope i am streering you in the right direction.

Thanks, Mate, Glad you like them.

Thanks, Mate, Glad you like it.

Thanks Mate

Thanks Mate, Glad to hear that it helped.

Thanks, Mate, good idea, I will have a look at it.

Thanks, Pete

Hi Mate, the first 2 shown are the most common depending on the situation for each corner.

Hi Pete, personally if I am doing 70mm framing I will try to use the 35mm thick timber as it works. Otherwise, if you are using 70 x 45 you will need to use a 25mm block that I generally have to rip down on site. Same with 90mm, 45mm works fine but the 35mm will require a 55mm block. Hope this helps.

Thanks mate, much appreciated. I agree, 35 mm mates it much easier, however some of this is re-work (well, more like trying to make the most of the mess somebody else left behind) and I'm sometimes trying to tie in to his brilliant handiwork. A lot of it I think will be easier to just rip out and start again from scratch but I need to draw the line somewhere. I thought I'd just rip some other timber down, but wondered if I was missing something obvious. Keep up the brilliant work.

Thanks Mate.

Thanks for your comment, Adel.

Hi, Yes Mate this all applies to steel as well as timber wall frames.

Hi Mate, Linear wall are just joined by butting the studs together.

@@Buildsum many thanks.

Hi Mate, thanks for your comment, sorry these are set up for the Australian Timber sizes which are 90 x 45mm or 90 x 35mm, When forming these intersections it is more common to use the 90 x 45mm section size. Unfortunately, the terminology tends to change from region to region however the term I try to use are the ones from the appropriate Australian Standards.

@@Buildsum yea i learned that from you after listening. you are very informative. wish out studs were like yours. sucks to be american i guess. lol