Excelente proyecto muy bien desarrollado y mejor ejecutado , esperando la segunda parte con impaciencia , gracias por compartir tanta creatividad y conocimientos , un saludo cordial y por supuesto un gran like desde Narón , Galicia ( España) 🤓 😜
Hi Fabian, sehr schöner Frästisch! Da der Bau meines Frästisches kurz bevor steht, wäre ich über einen Tip dankbar, wo du die Melanin beschichtete Patte her hast. Vor allen in der Stärke von 21mm bin in im Umkreis von Berlin noch nicht fündig geworden. Viel Grüße Thomas
Thanks, yeah I like it, too! The real reason for not edge-banding the top is laziness and I try to convince myself that the plywood edges look cool, too 😅
Love it. I made one very similar but I think I made a mistake by cutting my 4 inch dust port in the back of the router dust box. As a result, I am getting a lot of dust that gathers at the bottom of the dust box (below the router). Any suggestions to fix this?
Thank Anthony, yeah the bottom dust collection on mine not working 100% either. I think the solution to both our problems is inserting boards that act as a ramp towards the dust port. Should help the dust get to where it belongs. Sealing the center compartment could also improve the situation...
Why do people continue to keep so much of the bandsaw blade exposed when cutting material. I was always taught to keep about 1/4 inch or so above the material. Less chance of cutting off a finger. This is just common sense.