Thanks Bro 👊 🎉have the same problem at my 1.6 opc in Germany Its also a Corsa D from 2009 with a bigger Engine 192HP - the position of the crank sensor will be the same ? I bought the original sensor from the Opel (Vauxhall) Dealer and payed 112€ 😢Hope i can fix it
I'm having the same prob but with one thing different I turn the key to position 2 I get the F showing on the dash car won't turn over and all lights work exsept my reverse light, turn key off and on again if the reverse light comes on car starts up but will try and cut out wile driving any ideas pal
Hello..do you re-learn the sensor after installing it? or do you incounter problem after using the car ?or it keep working properly without problem...thanks waiting for your answer....
Afternoon, very helpful video! I own a Vauxhall Corsa SXI 2010 1.2 petrol. The start up of the engine seems to be struggling then when eventually starts up the idle revs sits abit too low around 400rpm and feels as if it’s going to stall but doesn’t. Any ideas where to begin? Thanks
Hi Mate, The question is where is the sensor located at engine block or the gearbox case ? Whilst removing the sensor from my corsa D 1.2 it just snapped in half then trying to pry it out it fell inside the hole can't get it out at all. I'm wondering where it has dropped which side engine or gearbox side near fly wheel. Help or advice would be appreciated. Thanks
mine 1000cc 2010 3cyl is running fine but the engine light is on, and scan says Cam shaft sensor - fitted a new one (but I didnt test it) and after reset the engine light goes out but comes on again (same fault)
2007 d having can chain changed and crank sensor. Already had a replacement crank sensor 6 years ago, came to remove it, the bolt was loose and the sensor was not fully home so had been leaking oil for a long time (owner had to top up regularly). Had to use screwdrivers to lever sensor out because it was very tight, New sensor won't even go down the hole, I would have to tap it in or sand it down a bit. Are there two different types of sensor for these engines?
I don’t think there is... it quite normal to have difficulties to remove the old sensor as they swell up just clean the hole just in case there is any gunk or debris, lubricate the new sensor seal and push in sometimes it takes a little bit of force to get pass the o ring 👍👍👍👍
Hello I have opel corsa D 1.2 gpl tech my problem is cranking too long before it starts..I use obd2 scanner but nothing light code...please help.thanks from Italy
Hi there, can anyone tell me why i can't turn off my spanner light on a vauxhall corsa 2010 1.3 diesel, the service as been done, i tried to reset the light, but it would go out, so i've put it on a diagnostics machine, it's telling me there are no faults with the car, car starts and drives fine. Thanks.
I have corsa 2010 reg 1.3 diesel it’s starts up after few minutes cuts out I’m struggling I don’t know what’s the problem is, -We change fuel pump Could you help please Thanks
Cars Exposed The local garage man says fuel rail pressure sensor we change it that bit as well still same problem. The car is starts fine after few minutes drive up it’s cuts out itself Thanks
Let’s start from the basics, when was the last time you have changed your diesel filter? Would be a good idea to hook up a pressure gauge at rail to know what sort of pressure there is when the car stalls, and perhaps do an injector leak back test ...
It could be but it would most likely trigger a code for it, needs testing ... if you have a code for lower pressure in the rail i would test everything around first....
That's right Scott it was a shame that i couldn't show it in the video because the car didn't want to start but it was on when my friend dropped the car off 👍
eduardo estrella remove the e10 bolt than pull the sensor out , sometimes it can be a bit stuck so try to twist and pull action eventually it should come out