Voltage Multiplier Circuits (Full Wave Voltage Doubler) 

In 3:14 ,you said DIODE D1 is F.B, but you put an open circuit there, i think it is REVERSE BIASED .

Thanks again: another very informative lecture.

Correction at 3.15 : Diode D1 becomes reverse biased. Thank you vey much for this! I was totally confused on figuring out how to determine if a diode is forward or reverse biased in a complex circuit until i came across this video. Thanks again

That's what exactly I want. An amazing explanation. superb!!!!

thank you

Best explanation so far

There is mistake at 3:15 that you said diode D1 is froward biased but actually it will reversed biased .

I didn't get the difference between Full wave voltage doubler and half wave voltage doubler. Can anyone explain it to me

How the capacitor 1 get charged +ve on upper side and -ve on lower side, in negative half cycle???

Nice explanation...

Thank you sir, nice analysis

Hi sir, can you post video on how to select capacitor type/value for voltage doubler circuit or others, with one example circuit it will help us to learn , i searched video in here no where i found it

Thank you sir

it will behave as a clamper circuit as the graph has been shift by a magnitude of Vm in the positive y direction

Will this damage my transformer? My coil can handle only so much voltage and ampacity. Will this device flow too much amps straight back into my transformer and over heat my coil?

sir, what is the difference between half wave voltage dpoubler and full wave voltage doubler? any advantages compared one to another?

How we will calculate output voltage using kvl in open ckt.?

Graph is needed

why did you not consider the capacitor voltages when finding the diode states? You just considered cycle states that are positive and negative. I am a bit of confused, is it a assumption for voltage multipliers?

Nice video. What value of capacitors would you use in this setup?

Sir will the capacitors will get charged to Vm or Vrms

Awesome, 👍

Sir for the negative half cycle you said p is connected to negative and n is connected to positive . So both are in FB . How is it possible.plz tell me air

can i apply full wave in half wave doubler circuit because result will be same as full wave doubler circuit .if iam right so why there are two circuit for half and full wave

waveform......?

According to me the direction of diode D2 should be opposite. Someone please clarify.

Amazing ..

Thnks

How it is different from half wave doubler can you explain in details

You should consider load resitence than it makes confuse

Graph bhi banakar dikha dete

Actually the fact is we have studied conventional current theory and you are teaching electronic flow of current. This is a bit confusing for most of the audience.

Confusing man

Pakistan HIT University Taxila: thank you sir

SIGN ULTY KUN LGATY HO

Thank you sir