VW Golf 5 headliner repair FULL PROCES POV 

Thank you very much.

ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE--7Z9d8KJVBM.html That one is even better

Thanks for the comment.

What was the hardest part of it? Ive been quoted £600 for mine which I'm not really prepared to pay so gonna give it a go myself. Any help appreciated!

@@Sam-np4ochow’s it going?

haha ended up finding someone to do it much cheaper so went with them. @@EastDallasKicks

Thank you for your comment.

I have done a few headlines over the years. First and foremost DON’T skimp on adhesive. Stay away from spray can adhesive. They don’t last.

Thanks a lot. I'm glad the video will be helpful to someone. You can slow down the video in the video playback options. Greetings

Thank you. I'm glad the video was helpful.

I'm glad the video was helpful.

Thanks for the comment.

It is not necessary to glue the canvas with foam, but since that is the case in the original, I used that canvas. Some ordinary canvas can also be glued, but the foam gives it a nicer final look. And it must be cleaned all the way to the shell, otherwise the glue will not be able to stick the new material. Good luck with the works. Greeting.

Thanks for the comment.

I used a regular round steel brush.

Yes, i used a fabric with 3mm foam.

I used Dunlop GP glue.

@@VDEdition1 Thank you sir.Regards

It is a canvas with a sponge behind it. Over time, that sponge burns and decays, and that's why the canvas hangs. To be able to glue anything, you have to clean the old sponge from the shell, and the canvas that is left is so thin that any glue you use will melt and be ugly. It is best to use a new canvas with a sponge. Good luck and thank you.

@@VDEdition1 thanks for the quick response

@@VDEdition1 one more question plz. I bought a fabric with 0,1cm thickness is it enough ? Thanks

@@El_Pertita I think it's enough, just be careful with the application of the glue. Apply evenly and thinly and make sure that there is not too much glue in some places, which will eventually leak through the canvas.

@@VDEdition1 thank you so much man

I'm glad the video was helpful. Thanks for the comment.

Thanks for the comment. Yes that is the glue that was used. It can also be applied with a brush, and I use an air gun for larger areas because it goes faster that way. Greetings.

I got contact cement because I couldn't find the glue you used anywhere, you think that would hold up fine? Awesome thank you so much!@@VDEdition1

I wasn't able to find that glue you're using, but I bought some weldwood contact cement to brush on, do you think that would be okay to use?@@VDEdition1

Hvala na savjetu.

Pozdrav. Svako čišćenje krovnog tapacirunga na kraju vodi ka odljepljivanju istog. Mnogi se pitaju zašto?! Zato što ispod platna, odnosno mrežice krovnog tapacirunga ima sloj spužve koja mu daje mekani, luksuzniji izgled, kada je sve novo. Vremenom ta ista spužvica propadne, izgori, izgubi svoju formu.. Korištenjem sredstava za čišćenje koji su ugl. hemijska baza tu spužvicu dodatno ošteti, a i samo trljanje krpom ili spužvom razdvaja platno od spužvice i u nekim slučajevima se odlijepi odmah a u nekim za neki određeni period. Dubinsko pranje će pogotovo oštetiti spužvicu i sve će se odlijepiti. Nadam se da ste dobili željeni odgovor. Pozdrav

Everything must be cleaned. If it cannot be scraped off then it is best to use nitro thinner to wash off the old glue.

Thanks a lot. I don't know how to get Dulnop glue in Germany. Try to find this product, it should be available in Germany.. "3M Headliner & Fabric Adhesive" great option also comes in a spray. Two sprays can be to finish the headliner. Good luck with the works.

No, it doesn't fit. Although at first everything looks similar, believe me it's not.

I apply glue on both sides, it's much better and safer.

Hot air.

This is a problem with all cars that use the same type of material, headliner material with sponge. After some time, the sponge burns and then the canvas starts to separate from it. I did repairs on Peugeot, Renault, Citroen, BMW, Mercedes, Lancia, Opel, Škoda, Seat, Volvo, Alfa Romeo, Toyota, Land Rover, Audi, VW, etc. My channel has videos from almost all of these brands listed.

@@VDEdition1 I repaired my Jetta by removing the headliner plastic completely leaving the carton base celan, then I painted all the carton with vinilic paint exactly with the same light gray color.

Thank you, I will work on it in the future..

Nu am inteles intrebarea?!

@@VDEdition1 vreiam sa spun cum se demontează plafonul la trapa? Ala mic de umbra

I get the materials from a local supplier of equipment for the auto industry and this is a material intended for headliners with 2-3mm sponge behind. You have the same ones on Ebay.."headliner fabric with foam". Good luck with the works.

Dunlop LP

Dunlop LP

No need to disconnect the battery.

Dunlop LP

@@VDEdition1gde ga mozes kupiti... Dali bi bio pattex universal classic dobar ili ne za taj posal...

I buy a new fabric with a sponge and install it.

Pozdrav. Nastavak za bušilicu imaš kupiti u svim većim prodavnicama koje prodaju alat. Što se tiče nanošenja ljepila četkom može i tako samo da ideš na što kraće etape jer ako ljepilo brzo suši onda moraš tako. Namažeš traku širine 10cm pa zalijepiš štof i sve tako dok ne dođeš do kraja. I nanosiš tanak sloj da nebi protopilo ljepilo kroz štof. Sretno

@@VDEdition1 Hvala ! :)

Ovako sam 100% siguran da se neće odlijepiti i do sada nije bilo nikakvih reklamacija. Prihvatam svaku kritiku, a i savjet je uvijek dobro došao. Ne mogu da nađem opciju da te direktno kontaktiram pa ću ti ostaviti svoj broj pa se možemo čuti preko viber-a ili WhatsApp-a 00387 61 323 351.

If you haven't done this before, it will take a few days to get everything back to how it was. I manage to finish everything in one day. Good luck with the works.

How is that possible?!

Dunlop LP

Danke für den Kommentar. Mir war nicht einmal bewusst, dass einige Teile des Tons entfernt wurden, wahrscheinlich aus Urheberrechtsgründen. Ich werde das beheben. Danke noch einmal.

What kind of glue? And do you suggest mainly working from the inside out?

Glue is Dunlop LP. You do everything as in the video and it's the correct procedure.

Steel brush and sandpaper

You need 2 meters in length and a minimum width of 140 cm.

I used Dunlop GP, although you can use any glue for the edges as long as it is heat resistant.

I do not disconnect the battery because there is no possibility to activate the airbags during disassembly. You can disconnect it if that makes you more comfortable. Greetings

Hvala. Kompresor koji koristim puni do 8 bara, a za diznu nisam siguran, morat ću provjeriti.

Pozdrav. Tokom ljepljenja su prevraćali materijal da nanesu ljepilo i na tim mjestima se spužvica "slomila" i ostali su kanali. Tu ne možeš ništa uraditi. Najbolje je ne dirati ništa. Pozz

@@VDEdition1 Dobro sam im platio da mi odrade profesionalno, bez ikakvih vidljivih linija i bilo cega. Da li to mogu smatrati nekom njihovom greškom ili se ti tragovi smatraju nebitnim iako su vidljivi? Koliko je teško odraditi a da se ništa ne vidi? Hvala na odgovoru

Jaki zespół konkretnie masz na myśli?

Thank you. I think you'll have to find someone near you to do it. :D

This is an original VW fabric. I don't know the exact name of the shade.

Ok Txs. I ended up buying a piece but it was slightly off.

The headliner in this video is the original headliner from this vehicle, the golf mk5.

@@VDEdition1 okay thank you

@@VDEdition1 do you know if a mk6 headliner would fit?

@@lloydsands6147 i believe it the mk6 will fit in mk5, only the mk5+ won't.

Thanks. I used a dedicated dunlop headliner glue, resistant to high temperatures.

Dunlop adhesive

Dunlop adhesive

Thanks a lot.

Thx! 👍

Thank you. I'm glad if the video was helpful.

thank you