I’m looking for a way to adjust the volume of the loop. On my headrush there is a mix knob to where I can lower the volume of the loop some to hear the next loop louder. Never mind the answer was towards the end of the video.
Does this looper always waits for your sound to start recording?? Or I can also start to record immediately ?? Cause some songs don’t start on the very first beat... cheers ❤
Is there a way to open the looper x menu with a footswitch while in scene mode? I know you can use the ^ to close it but want to flash in and out of it while in scene mode. Much appreciated in advance. Fyi im in the latest firmware as of 12/5/23
So momentary switch mode allows to immediately record only while it’s pressed down? Right? So u can capture any region. From very short stutter to long drone. Right? Cheers beers brother ❤❤ your videos great.
In toggle mode, you press the punch button to start punching in, and then press it again when you’re done punching in. In momentary mode, you hold the switch down for the length of time that you want to punch in
I started this for the looper and started for the jam. I must say, that’s a rare occasion my dude. I’ve been playing like 22-23 years, teaching for almost 15, currently pursuing a masters degree in Guitar Performance. And in my (humbly, kinda lol) qualified opinion, that’s one tastyyyyy solo/improv right there. Just enough to hear your influences yet sound pretty original. Ii especially loved the Beck-ish stuff at the end
I’ll have to check this out, but off the top of my head you will lose the loop if you change the preset. However, this is why the Scenes/snapshots exist, so that you can use those as ‘preset changes’ within the same preset.
As long as you change between two presets which *both* have a looper block, then the loop will not be lost. As soon as you change to a preset which *does not* have a looper block, the loop will be lost.