Xr650L Rebuild Part 4 - Reinstall Valve Cover, Carburetor, Exhaust, Valve Clearance

Подписаться 47 тыс.

Просмотров 4,4 тыс.

50% 1

Initial Video
• I Got a Free 2006 Hond...
Inspection Camera Diagnosis
• Harbor Freight CEN TEC...
Link to Service Manual I used
archive.org/de...
Rebuild Kit
www.ebay.com/i...
Cylinder
japan.webike.n...
Due to factors beyond the control of Hank's Garage, I cannot guarantee against improper use or unauthorized modifications of this information. Hank's Garage assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Hank's Garage recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Hank's Garage, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Hank's Garage.

Опубликовано:

16 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 7

@garygary8645 2 года назад

Can't wait to hear\see it run. Thanks for the video

@alijalali5729 2 года назад

Was very good and full of the details.🇯🇵🗾👍🙏🏍️

@butler386 2 года назад

Moving right along with the bike. You probably said in an earlier video about the size of the engine but I have forgotten. Can you tell me what is the engine size? Looks like you will have a good runner when you are done. Hoping to hear it run soon. Thanks for the videos.

@sergiuadrianspulber2636 2 года назад

Hi. How did you make sure that the rocker arms that are attached to the valve cover are fitting properly on the valves? I can't figure it out no matter what I've tried.

@patrickczernizer2317 2 года назад

Hey probably a stupid question. But I got the engine back together and when hand cranking I don't see the valves or cam moving at all. Before I put the valve cover on the cam and chain were moving. Now I don't see it moving. The tension went in good and everything tight. Thanks

@psicovirus Год назад

Perhaps the chain is off the crank shaft sprocket?

@Josh-co7pz Год назад

As mentioned, most likely the cam chain is not on the lower sprocket. Without the tensioner and camshaft install you can seat it onto the lower sprocket by manoeuvring it from the top end