Hi Max, this PCB is not to replace the stock TCM. This is to bypass the valves inside for the use of aftermarket controller, hence can't be used with standard installations.
@ryutech_automotive is there a difference in PCB between an HTG and a Turbo Lamik? The reasoning behind the question... Let's say, I'm using an HTG TCU, then decided to switch to Lamik. Will there be a difference between the circuit boards?
Nice work man iv just plugged in my turbolamik and i have a short to ground fault on speed sensor 2 do you think i possibly messed up with the soldering or mashed the sensor putting it back together
Ooh this was painful to watch for many reasons. I've got one of these gearboxes. No idea what this modification is for, but I can solder, I'm an engineer, Painful. Use a toothbrush to leave any metal filings on top of the old circuit board? Mental.
The fact that you have no idea what this is for; an 'engineer' would think about searching google for 'why' and try to understand complexity of modification rather than thinking 'painful' :)
@@ryutech_automotive Brutal bro, he could be a bridge engineer right? Also his comment seems spur of the moment, and he just didn’t care enough to research. But I do see your point as well.
@@MechaniclifeJDM The solder methods in the video might not be the best, nor using the best of equipment, the purpose of this is that installers (garage) can follow through with off the shelf tools. He does have a point for using toothbrush, but if you ever do the modification you'll know that it is quite frustrating to clean thoroughly.