10 месяцев назад

We begin our big channel project of machining all of the castings for the USA made Fireball Tool Hardtail vise! This will be a long ...

10 месяцев назад

We'll get the main body setup and finish machining the fixed jaw mounting surfaces. This will compete the external surfaces of the ...

6 месяцев назад

I'll finish up the final touches needed to the fixed vise jaw body to allow proper fitment of the dynamic jaw to slide through properly.

6 месяцев назад

As we get to the final machining needed for our Hardtail vise, we'll get the inside area of the fixed jaw body machined to fit the ...

Год назад

This video will kick off a new video series involving new tools, used tools, tool repair, precision tools, and even machine tool ...

10 месяцев назад

As we continue on with machining the castings for the USA Hardtail vise, we'll set up the main body and machine the anvil and tail ...

8 месяцев назад

We continue with the second setup for the new swivel bolt using our @MilltronicsUSAInc TRM 3016 cnc mill. Instead of milling a ...

8 месяцев назад

I wanted to replace the factory made cast iron swivel bolt with one that I machined myself from a piece of 4140 steel. This was a ...

10 месяцев назад

The next part of our USA Hardtail vise build to machine is the swivel base. This will be completed in two setups. In this video we'll ...

7 месяцев назад

The final machined surface for the swivel base I wanted to pull off on the cnc mill. With Fusion 360 I used a 2D Bore cycle to ...

9 месяцев назад

We fire up the ole Gould & Eberhardt 32" Industrial metal shaper to help us get started on the machining for the hardtail vise ...

9 месяцев назад

Our next machining setup for the dynamic jaw will be on the old Kearney & Tracker 307 S-12 horizontal milling machine. Here will ...

9 месяцев назад

I show how I make the finishing cuts using the shaper on the bottom side of the hardtail vise dynamic jaw body. #abom79 ...

9 месяцев назад

We continue the machining for the vise swivel base getting both sides machine flat and parallel. The second setup I opted to ...

6 месяцев назад

We finish all of the machining for the tail housing, also called the Hardtail and get it and the nut installed onto the vise body.

8 месяцев назад

We're back on the old K&T mill to begin workong on the the counterbore for the thrust bearing and the two holes that are drilled ...

7 месяцев назад

No machining in this episode. We'll get the Hardtail vise dynamic jaw all setup in the @MilltronicsUSAInc TRM 3016 and our ...

8 месяцев назад

We're back in the K&T mill and will now get the dynamic jaw body drilled and tapped for the bolt on jaws. I use our extended reach ...