Take a video about this , The world is now ruled by one community of people, the world Satanic elite, you can also call them the committee to meet the Antichrist and prevent the 2nd coming of Jesus, Trump called them the deep state, at the moment it consists of about 10,000 people, the main ones there are Rockefellers, Rothschilds, Windsors, Baruchs, they, their ancestors, descendants and other people who enter there have the mark of Lucifer, which, if they bring the antichrist and do not allow the 2nd coming, they will receive eternal life after the x hour, and the rest of humanity, for all the time that they have lived, they won't get anything, so all people should know about the existence of a world government (Jesus who was a The Prophet of God, not God.God will send Jesus as a reward to humanity, if humanity deserves it, for this it is necessary to fight Lucifer and his elite)
whats more impressive than km/h, on 11:06 it says "222 A"... these are... ampere? what? also the number above is, im guessing, battery percentage, it dropped from 80 to 40 in seconds... motors in one moment pulled 9 KW... all of that in a small package so it can fly in the first place... you guys went all in, either guinness record or end up in flames, no half assing, hats off to you sirs!!!
great work. congrats for the sucess, and amazing job on the video ! I apreciate that you share so much about the design, the whole process, the parts use :) great content :)
Seems to me that frontal surface area can be reduced a lot, while not increasing too much the wetted surface. Also the overall shape must be of a laminar airfoil.
Hey @LukeMaximoBell1, Congrats with the world record! I loved this video. I was wondering if you ever tested other type of propellers (silent zipline propeller or toroidal propellers)? Do these reduce the speed of the drone (whilst reducing the annoying drone noise)? Thanks!
Probably better knowledge of electric measurements, few formulas and reading the spec sheets of the electronics used, would have avoided so many bursts in flames... Especially when wires are catching fire, that is caused by not paying attention to their ampere rating, or mistakes in the calculations on wires were needed
Generally when a motor comes from a manufacturer one would assume that the wires that come installed with a motor are thick enough. However this is an extreme use case and as our testing proved on the bench instead of in flight these wires were too low of a gauge. When doing practical engineering things do not always go to plan.
This would make a really impressive kinetic energy weapon. If the drone weighed 1kg it’d be delivering over 90K ft/lbs whereas a 50bmg round delivers 10 to 15 thousand foot/pounds.
Did you guys do the ole measure diagonally for the motor mount holes and then find out it was side to side?? I’ve done that a few times. Also I might have to try my hand at the record now! Looks awesome!!
It is sad that you don’t even vaguely try to do any actual engineering. Your wire test should have been done in half a minute with a simple calculator. You are providing horrible examples of how to design things. Indeed, you are not designing them at all. You are just randomly guessing.
Your comment applies that you have no practical engineering experience. 1. Those wires come factory standard for those motors. This is an extreme use case which is why they failed. 2. The way I constructed the video is somewhat for comical effect which is why it seems like I don’t know what I’m doing sometimes. 3. When actually engineering something you can do as much theory and calculations as you would like. Practical trial and error is often what prevails.
