It's funny that I'm being interrupted at work while trying to watch this video, also I don't like how the video is small when you're watching it on the phone because of the sizing, I'm so irritated
So funny I was at a QuickCheck I've been going to for years, so I know everyone there & one lady couldn't figure out how to load the label gun. I asked her for it & searched your video & got it done fir her while I waited for my order. Thanks!👌🔥
Amazing how many people either don't know this or don't believe it. And so far I haven't found anyone who knows why it's better to use a crescent wrench in the correct direction. I don't see why these people can't tell the deference by simply trying the damm things both ways. You can literally see them rounding off the nut when used the wrong way. If you look at the angle of the handle it appears to be pulling the wrench off the nut when used the wrong way.
Do you happen to know how to turn off this ice maker? I have the same one, and cannot find an off switch or move the arm to stop the ice making process
I believe if the arm stays up it will stop making ice. The problem I have is I don't have this refrigerator or ice maker anymore. so you might try to tape it up for a day and see if it stops making ice but there has to be a way to just turn it off.
Exactly my thoughts. Those boots are not Fake. The misaligned stitches is a sign of poor QC. I Been to the TIMBERLAND OUTLET and I saw some that didn't have parallel stitches. The Absence of a Green TIMBERLAND LOGO tab is also not indicative of Fake as some do and others don't. Mine have a tab on one boot but not on the other. The CLEAR, PRECISE numbering and wording tells me it's real. Also, the tongue looked stiff and thick whereas the fake have a sloppy flimsy tongue. I would have liked to see the insole and the foot bed sole as that is where the KNOCK OFFS show. Real TIMBERLAND have stamping on the foot bed and the insole as well. If infact it's a fake it's a real good fake and would certainly buy it.
The weird thing about the 2008 Ford Taurus SEL is the Advanced Auto Parts guy told me the rear turn signals use a 4157 bulb but the2 front turn signals uses a 3157 bulb. I had to use a 7/16 wrench on the 4 rear bolts holding the bulb in place but they are just finger tight now.. Someone used the wrong bulb on my front signal when it was replaced a few years ago. WRZ 2023-01-11 Delaware County, PA
@@mkjgry I'm assuming the guy at advance auto parts was correct. But this was probably the reason one bulb was replaced incorrectly. I just wanted to see if anyone would contradict what I wrote.
Just replaced my light. Video was a big help as you knew what to expect. Little tricky getting the light back into the housing. Everything works. Thanks.
