it kinda looks like maybe the ejection port might be slightly longer than it should be because the brass makes almost a complete 180 before it has completely left the port, but that also could just be my perception from the video angle
So I just waited an almost two days for theSL- 15 I used it a Creality filment dryer on my ender 3 S1 pro with a harden steel nozzle at 280 nozzle temps 50c bed temp it was ploymide PA6-CF . My first time using this filament .. ran the dryer it while printing use painters tape on the bed for better adhesion minimal warping … so I attach the new upper to it after printing… an left it on . Then I wasn’t paying attention and knocked it over on to the carpet and crack my finished print and now I’m back at square one what can I do to prevent this again .. I wanted it for the heat resistance but it cracked on the first drop it took .. please I need suggestions only have enough to print one more lower thanks
Do the British not have hardware stores? You can build a zip gun for 30 bucks in the plumbing section, getting rid of 3D printers isn't going to change anything. Philip Luty proved that way back in 98.
I like the shape you chose for the pistol grip, it looks like a BCM Mod-3. My problem with most integrated pistol grips on ar-15s is that without fail they always use a shoddy design that hasn't been thought out and often is just an A2. The fact that you spent more than 5 minutes thinking about it makes you better than the big brands and the "professionals".
